User manual ACOUSTI PACK PRE-CUT KIT FOR ANTEC SONATA III

[. . . ] The thickest acoustic composite sheet features the unique AcoustiContourTM anechoic surface. Fitting Recommendations It is IMPORTANT that the materials in this AcoustiPackTM are carefully installed - please take a moment to read the following recommendations. [. . . ] Once these have been measured and cut, it will reveal how much of the remaining material can be used for more intricate locations. Where selfadhesive is on the reverse of the materials, remove the backing paper and adhere lightly to clean, dust-free surfaces. If you make a mistake positioning materials - they can be re-applied for a second attempt - but be aware that excessive re-application will cause a deterioration in the adhesive. After installation we recommend that system and component temperatures are monitored. This sheet could, for example, be located on the inside of the opening case side panel where there is usually enough room for thicker materials and adequate ventilation for nearby components. Important!READ THIS BEFORE installing the materials in this pack: DO NOT cover the ventilation holes at the rear of the case with any materials. DO NOT position the rear of the case close to a permanent heat source, such as a radiator, or very close to an airflow obstruction, such as a wall. Leave a gap at the rear of the case of at least 20cm to allow free movement of air in and out of the case. [. . . ] DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components, especially cooling fans, disc drives and moving parts. [. . . ]