User manual ACOUSTI PACK SFF (SMALL FORM FACTOR)

[. . . ] Acoustic Foam Fitting Directions: Fit according to the positions indicated, in the numerical order shown from 1 to 17 . [. . . ] Where self adhesive is on the reverse of the materials, remove the backing sheet and adhere lightly to clean and dust-free surfaces, making sure that the material is correctly positioned. If you make a mistake - it can be re-applied for a second attempt - but be aware that excessive re-application will cause a deterioration in the adhesive. Ensure you read the important safety information before installing the materials. GAP 18mm Acoustic Composite Opt = Optional Note Regarding Part 13 : 3½-inch drive bay mounting is shown removed for clarity. Removal may not be required for fitting part 13 . 13 1 Opt 15 Part 7 goes on the inside of the frontpanel hinge door. Note Regarding Part 1 : 1. DO NOT cover any necessary ventilation holes in the case with materials. DO NOT position the rear of the case close to a permanent heat source, such as a radiator, or very close to an airflow obstruction, such as a wall. Leave a gap at the rear of the case of at least 20cm to allow free movement of air in and out of the case. DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components, especially cooling fans, disc drives and moving parts. [. . . ] DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components, especially cooling fans, disc drives and moving parts. [. . . ]