User manual ACR ELECTRONICS RCL-100

[. . . ] The Searchlight is totally enclosed and is made of rugged aluminum alloy. The Searchlight can be mounted where desired, using appropriate length 3/16" diameter, stainless steel fasteners. Four (4) nylon shoulder washers are supplied with the RCL-100D Searchlight. The nylon washers prevent a galvanic reaction between the mounting hardware and the base of the Searchlight. [. . . ] Wiring to Searchlight The RCL-100 Searchlight is supplied with a 15 foot integral wire harness. This wire harness is cut to this length specifically to allow for a voltage drop. Any extra length of wire harness should be loosely coiled in a convenient place. For best performance, the controller should be attached to the end of the 15' Searchlight wire harness. If you must lengthen the wire harness, use heavy duty wire to minimize the voltage drop. This is especially important for the YELLOW lamp power and GREEN lamp ground wires. Following the wiring scheme shown in Table 1 use the supplied butt connectors to connect the Master Controller to the Searchlight. Wiring to Point PadTM The RG-59 Coax cable is supplied without the "F" connectors attached for ease of routing. After the coax has been routed, strip the insulation and crimp the "F" connectors in place. Screw the "F" connectors to the Master Controller and the Point PadTM. Wiring to Power Supply The power source must be a fused 12 VDC, 10-amp supply or 24 VDC, 5-amp supply. Following the wiring scheme in Table 1, use the supplied butt connectors to connect the Master Controller to the Power Source. Refer to Table 2 for proper wire size for connection of the input power lines. Y1-03-0138R 11 NOTE: As per the wiring scheme, the ORANGE wire is connected to the Positive terminal and the BLUE wire is connected to the Negative terminal of the power source. CAUTION: Observe polarities when attaching wires! Maximum Cable Length Wire Size #8 AWG #10 AWG #12 AWG 12v System 25 ft. 40 ft. Table 2 Function The URC-102 Master Controller is designed to perform up to six different duties on searchlights, winches, and other electrical devices. The Master Controller provides optimum voltage to ensure brightest performance and long lamp life, regardless of boat system voltage fluctuations. The Master Controller is compatible with devices requiring 12 VDC or 24 VDC operation. The XRCiZTM feature routinely operates all moving parts in the Searchlight to keep the motors and drive mechanism freely running. Once activated, and every 30 days thereafter, the XRCiZTM feature wakes up and operates the Searchlight. The Searchlight will rotate 360 in both directions and the parabolic reflectors will move to the full up and down positions. This feature keeps the Searchlight in peak working order when not in service for long periods of time. To activate the XRCiZTM feature, press and hold the Point PadTM ON/OFF button for greater than 5 seconds. [. . . ] To ensure that you have the most recent version of the Product Support Manual, please visit the ACR website at www. acrelectronics. com. Reproduction in whole or in part is permitted only with permission of ACR Electronics, Inc. Ongoing product improvements may change product specifications without notice. Trademarks or registered trademarks are the property of their respective owners. Y1-03-0138R 22 EC DECLARATION OF CONFORMITY ACR Electronics, Inc. [. . . ]