User manual ADCOM ACE-315

[. . . ] b c d ACE-315 Introduction The ACE-315 is a very carefully engineered product designed to protect your audio system while providing it with clean AC power. patents 4, 870, 534 and 4, 870, 528) that conforms to the strictest Federal Guidelines for surge protection. ACE-315 AC enhancer switched unswitched ef out coax in gh i j 1) 1! Surge Protector and AC Enhancer model ACE-315 voltage: 120V AC/60Hz, internal power consumption: 10w max 1@ 1# 1$ 12v trigger CIRC UIT BREA KER max 1800W bank 2 switched bank 1 unswitched (always on) in S S TO R E phone out in GND WARNING: For indoor use in dry locations only. [. . . ] In the unlikely event damage has occurred, notify your dealer immediately and request the name of the carrier so that a written claim to cover the damage can be initiated. The right to any claim against a public carrier can be forfeited if the carrier is not notified promptly in writing and if the shipping carton and packing materials are not Connections Optional: Attach the supplied color-coded AC cord labels to each AC cord to be installed. Place a label at each end of the AC cord to easily identify which cord is connected to each product. System AC Connections Begin by connecting products which require full-time AC power to the rear panel jacks labeled "unswitched" 1). Connect the remaining AC power cords to the rear panel "switched" AC outlets i, j. Symbol explanations Grounding Screw The grounding screw 1!provides a convenient system grounding point where one or more of the components is not equipped with a three prong AC cord. The entire system can be grounded by simply connecting a wire between the chassis of any system component and the ACE-315 grounding screw 1!. (The remaining components will be grounded to the ACE-315 through the various audio and video coax connections. ) NOTE: All outdoor cables must be properly grounded prior to entering a building. See the Safety Instructions section for further details. Operation The unswitched front panel LED d indicates that AC current is passing through the ACE-315 and into the components connected to the unswitched AC rear panel outlets 1). The unswitched LED d is always on provided the unit is plugged into an active AC source. Phone Line Connect the phone line from the wall outlet to the phone in jack e. Connect the phone out jack h to the line input of a modem, DVD, TiVo, DSS receiver, or pay-perview cable box. Front Panel Control Press the ACE-315 power button b to activate the unit. AC power is being supplied to all connected components. Remote Triggering The ACE-315 may be remotely activated and deactivated using a low voltage trigger signal available from most contemporary preamps and receivers. Connect the trigger out jack of the preamp with the ACE-315's 12v trigger in jack 1@. Multiple Amplifiers When connecting more than one amplifier to the ACE-315, install the first amplifier into one of the "bank one" j AC outlets. [. . . ] To reduce the risk of shock, do not expose this unit to rain or moisture. serial # WARNING: Equipment with high-current requirements, such as hobby arc-welders, hair dryers and heaters must not be plugged into these AC receptacles. Never allow total power consumption of all equipment connected to these outlets to exceed 1800 watts. 10 Timber Lane Marlboro, NJ 07746 USA Made in the USA power 120v 60Hz max 1800W amplifier 2 from wall amplifier 1 preamp VCR DVD CD preamp SE T KER PR E to AC outlet to device [. . . ]