User manual ADCOM GDV-850

[. . . ] GDV-850 Progressive Scan DVD-Audio/Video Player ADCOM GDV-850 Owner's Manual | 1 WELCOME Dear Fellow ADCOM Product Owner, Welcome to the ADCOM family!For more than twenty years, ADCOM products have delivered excellent performance and value for customers around the world. Our products are designed by our experienced and demanding engineering team, built to the highest standards in our factory, and sold and serviced through dealers, custom installers, and other retailers whose primary goal is your complete satisfaction. We know you are anxious to see and hear your new DVD player in action, but please take a few minutes to read this owner's manual before connecting the DVD player to your system. [. . . ] char1 POWER ON: 1 = Unit is Powered UP 0 = Unit is Powered Down , char2 STANDBY: 1 = Unit is in Standby mode, 0 = Unit is out of Standby char3 VIDEO OFF: 1 = Video is OFF, 0 = Normal operation char4 AUDIO OFF: 1 = Audio is OFF (mute), 0 = Normal operation char5 DIGITAL OUT: 1 = SPDIF output is ON, 0 = SPDIF output is OFF char6 HDCD: 1 = HDCD disk playing, 0 = Not HDCD char7 DVD AUDIO: 1 = DVD Audio disk playing, 0 = Not DVD Audio char8 P-SCAN: 1 = Video format 480p, 0 = Video format 480i V. Syntax: "V" Returns: "v", <n1>, <n2>, <CR>, <LF>, ">" Where: <n1> and <n2> are ASCII characters indicating the firmware revision level. Syntax: "R", <char1>, <char2> Returns: "R", <CR>, <LF>, ">" (i. e. 0x52, 0x0D, 0x0A, 0x3E) Where: <char1> & <char2> are expressed as ASCII `hexadecimal' values per the following table. 0x52, 0x33, 0x30) = SLOW 16 | ADCOM GDV-850 Owner's Manual Function and Data List for GDV-850 (Discrete) Remote Control via IR Custom Code: 1Ah E5h Code Type: NEC Carrier Frequency: 38kHz Command eject_key setup_key pbc_key key_0 key_1 key_2 key_3 key_4 key_5 key_6 key_7 key_8 key_9 key_plus_10 clear_key slow_key step_key stop_key title_key ff_key previous_key ntsc_pal_toggle select_ntsc select_pal next_key zoom/left_key zoom/down_key angle_key sub_title_key audio_key menu_key zoom/up_key power_key zoom/right_key power_on power_off bitstream_on bitstream_off select_ire_0 select_ire_7. 5 play_key _no_key zoom_in_key goto_key resume_key select_rgb_out component_out video_off_key mute_key repeat_key set_a_key _no_key GDV-850 Function opens/closes disc tray enters GDV-850 setup mode turns playback control on/off _key_0 _key_1 _key_2 _key_3 _key_4 _key_5 _key_6 _key_7 _key_8 _key_9 _key_plus_10 disguards numbers entered by remote retards playback advances frame-by-frame exits playback plays/enters title on disc forward advanced rate of playback selects chapter before current, start track switches between video formats selects ntsc selects pal selects next chapter/track navigates left in menu and zoom mode navigates down in menu and zoom mode selects alternate angle when available turns subtitles on/off selects alternate audio track enters dvd digest navigates up in menu and zoom mode turns GDV-850 on/off navigates right in menu and zoom mode turns GDV-850 on turns GDV-850 off engages bitstream from disc deselects bitstream from disc sets IRE level to 0 sets IRE level to 7. 5 engages available media turns screen on scales images up goes to a specified part of disc resumes playback selects rgb output selects component output mutes video output mutes audio output repeats current track/chapter or all creates a looping playback from selection _fb_key 0000 0100 32 1000 0100 33 0100 0100 34 1100 0100 35 0010 0100 36 1010 0100 37 1111 1110 127 1110 0100 39 0001 0100 40 1001 0100 41 0101 0100 42 1101 0100 43 0011 0100 44 1011 0100 45 1111 0100 47 0000 1100 48 1000 1100 49 0100 1100 50 1100 1100 51 0010 1100 52 1010 1100 53 0110 1100 54 1110 1100 55 0001 1100 56 1001 1100 57 0011 1100 60 1011 1100 61 0000 0110 96 1000 0110 97 0100 0110 98 1100 0110 99 0010 0110 100 1010 0110 101 0001 0110 104 1001 0110 105 0101 0110 106 0011 0110 108 1011 0110 109 1111 0110 111 0000 1110 112 1000 1110 113 0100 1110 114 1100 1110 115 0010 1110 116 1010 1110 117 0110 1110 118 1110 1110 119 0001 1110 120 1001 1110 121 0101 1110 122 1101 1110 123 0011 1110 124 ADCOM GDV-850 Owner's Manual | 17 IR: D7~D0 Deci 3. 1 Front Panel Display Illustration Title/Group State Status Disc Type Audio Format Chapter/Track Remain Time A, Z, Z, R, Function L Audio Channel 3. 2 Display Overview A lighted display on the front panel of the GDV-850 provides information about the status of the unit, activation of special features, and track/ time information. See the illustration above for the location of each section of the display. 3. 3 Display Features Title/Group: displays the number of the current Title or Group. Status/Disc Type: displays the current status of the unit (Open, Close, No Disc, etc. ). When a disc is playing, this section of the display shows the sampling rate and format of the disc (DVD-V 48kHz, DVD-A 96kHz, etc. ) Audio Format: displays the audio format of the inserted disc (Dolby Digital, DTS, PCM, etc. ) Remain: shows the letter R when the remaining time of disc or selection is being displayed. Function: indicates which special features are activated, A in the first segment for angle, Z in the second and third segment for zoom, an indicator for the type of repeat in the fourth segment, and an L in the fifth segment when the OSD is being shown during setup or when playback is stopped with the resume feature storing the current position on the disc. Audio Channel: shows which of the six possible audio channels are in use. 2/0 indicates a stereo signal, 3/2 indicates a five channels with three front and two surround, and 1CH to 6CH for DVD-A discs. Language selection, Time Display, Repeat Mode, etc. ), indicators appear in the On-Screen Display showing the current status of that feature as you make changes. NOTE: A hand icon is displayed when a button press is not a valid operation accepted by the unit for the disc you are playing. Menu Screens A number of menu screens can appear during configuration of the GDV-850 such as the sample below: 3. 4 OSD Overview The GDV-850 displays icons, status indicators, and interactive menus on the TV monitor. Many of these screens are used to set up preferences and activate advanced features of the unit. Others offer information and choices useful during normal operation of the unit. NOTE: The default language for all GDV-850 On-Screen Displays can be changed. See the General Setup topic in the Setup section of this manual. Status Indicators During operation of the unit, various status indicators appear on screen such as NO DISC, LOADING, PLAY, PAUSE, etc. When using specific features during playback (such as The menu screens provide access to various settings and features described in the next section of this manual. The menu system appears when the setup button is pressed, typically whether the disc or stopped or playing. The on-screen display ("OSD") menu does not appear when a DVD-A disc is playing. The Preferences menu screens are only available when disc playback is stopped. 18 | ADCOM GDV-850 Owner's Manual GDV-850 Setup Menu 4. 1 Setup Overview All configurations for the GDV-850 are made in the setup menu. The setup menu is displayed on the OSD and accessed with the setup button on the GRC-815 remote control. When the setup button is pressed your source material, if playing, is paused and a transparent blue menu is displayed over the source video. Please note that not all options can be modified while source material is active. [. . . ] Limited Two Year Warranty (Home, Non-Commercial Use Only) ADCOM warrants this product against defects in materials or workmanship for a period of two (2) years after the date of original retail purchase from an ADCOM authorized dealer. During this period, ADCOM will repair or replace a defective product or part, at our option, with a new or refurbished product or part without charge to you, as long as you follow the procedures listed below. Limited Ninety (90) Day Warranty (Commercial Use Only) ADCOM warrants this product against defects in materials or workmanship for a period of ninety (90) days after the date of original purchase from an ADCOM authorized dealer. During this period, ADCOM will repair or replace a defective product or part, at our option, with a new or refurbished product or part without charge to you, as long as you follow the procedures listed below. [. . . ]