User manual ADVANCE ACOUSTIC MAA-1000

[. . . ] This symbol on the product or on its packaging means that your electrical and electronic equipment should be disposed at the end of life separately from your household wastes. For more information, please contact the local authority or the dealer where you purchased the product. ATTENTION: afin de réduire tout risques de chocs électriques ou de feu, ne pas exposer votre appareil à l'humidité ou à toutes sortes de liquides WARNING: to reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. [. . . ] Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. HEAT The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliance (including amplifiers) that produce heat. POWER SOURCES The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. POWER-CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked on or pinched by paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. CLEANING The appliance should be cleaned only as recommended by the manufacturer. POWER LINES An outdoor antenna should be located away from power lines. NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. Don't place the unit sideways, a big power exerts on the single side of the plate. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. Also, they integrate the signal over a short enough time to give an accurate representation of the average power. [. . . ] In this mode, the temperature of your amplifier will be important, also, it's important that there should be enough clear space around the amplifier to permit a free flow of air. DIMMER (DIM) Your MAA-1000 power amplifier have a three positions dimmer function: OFF, Normal and Max (Maximum). OFF mode will switch off the meter light, in normal mode, the brightness of the meter is limited and in Max - (Maximum), the light on the meter is very intensive. [. . . ]