User manual ADVANCE ACOUSTIC MAP-308 QUICK START

[. . . ] CAUTION: To prevent the risk of electric shock, do not remove cover (or back); no user serviceable parts inside. THE LIGHTNING FLASH with arrow-head symbo is intended to alert the user to the presence of uninsulated «dangerous voltage» within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Before any transportation, your product must be packed correctly in order to avoid any damage. [. . . ] CLEANING The appliance should be cleaned only as recommended by the manufacturer. POWER LINES An outdoor antenna should be located away from power lines. NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. Don't place the unit sideways, a big power exerts on the single side of the plate. The window of the meters is antistatic treated, also, it's very important to clean it with an antistatic approved liquid. To switch on the Power amps direct function, please push "Normal/Amp" button of the remote control during 3 seconds. To cancel this mode, please push on the "Normal/Amp" button of the remote during 3 seconds. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. VOLUME BUTTON Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. [. . . ] GROUND SCREW TERMINAL FOR TURNTABLE Connect the ground wire from your turntable here. HIGH BIAS SELECTOR By switching the High Bias mode in ON mode, your amplifier will be similar as a Class'A amplifier of the first watts of use. In this mode, the temperature of your amplifier will be important, also, it's important that there should be enough clear space around the amplifier to permit a free flow of air. [. . . ]