User manual ADVANCE ACOUSTIC MAP-800II

[. . . ] CAUTION: To prevent the risk of electric shock, do not remove cover (or back); no user serviceable parts inside. THE LIGHTNING FLASH with arrow-head symbo is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Before any transportation, your product must be packed correctly in order to avoid any damage. [. . . ] All other servicing should be referred to qualified service personnel. POWER-CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked on or pinched by paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. CLEANING The appliance should be cleaned only as recommended by the manufacturer. POWER LINES An outdoor antenna should be located away from power lines. NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. Don't place the unit sideways, a big power exerts on the single side of the plate. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. BOUTON DE VOLUME Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. PHONO INPUT Press this button to select the phono input as your listen source. the audio signal of phono is an analog RCA type connector plus an additional ground. [. . . ] POWER CORD /MASTER ON/OFF SWITCH / VOLTAGE SELECTOR Before plugging in the amplifier, its master power switch must be in the OFF position. In case that you need to use your appliance in 115V, you need to change the position of the voltage switch and to replace the voltage fuses by those included in your product. 1 If your cd player or others sources has stereo balanced outputs, you can connect them on the stereo balanced cd input or Aux. [. . . ]