User manual ADVANCE ACOUSTIC X-PREAMP

[. . . ] WATER AND MOISTURE The appliance should not be used near water for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. VENTILATION The appliance should be situated so that its location or position does not interfere with its proper ventilation. Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. HEAT The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliance (including amplifiers) that produce heat. [. . . ] The standby indicator red lights during standby w AFFICHEUR GAUCHE Cette afficheur vous indiquera plusieurs informations en fonction du menu sélectionné. In INPUT source mode, it will display the input source selected, in BALANCE mode, the right and left level, in BYPASS mode if this mode is OFF or ON, in DIMMER, the light level of the front panel, in INFO mode, the software version of the preamplifier. IMPORTANT: When the BYPASS mode is OFF, two additionnal menus appears to control treble and bass levels. If BYPASS ON is selected and if you push treble or bass buttons on the remote, the display will indicate “KEY ERR“ to advise you that in this mode you can’t control treble and bass levels. e BOUTON MULTIFONCTIONS Ce bouton possède trois fonctions: il vous permet de régler le volume sonore de votre préamplificateur , de sélectionner les différents menus et options de votre préamplificateurs (Sources , balance , bypass (On ou Off) , Treble (seulement si le bypass est Off) , bass (seulement si le bypass est Off) , intensité lumineuse de l’affichage et version du logiciel) et de valider vos choix en appuyant au centre de ce bouton. MULTIFUNCTIONS BUTTON This button has three functions: you can adjust the level of the sound, you can select the different menus and options of your preamplifier (Inputs, Balance, Bypass (On or Off), Treble (only if bypass is Off), Bass (only if bypass is Off), Dimmer and Info (software version). r t AFFICHEUR DROIT Cette afficheur vous indique le volume choisi. LEFT DISPLAY This display indicate the level of the volume PRISE CASQUE 6, 35MM La sortie casque de votre préamplificateur permet d’alimenter un casque stéréophonique conventionnel (non fourni) disposant d’une prise de type jack 6, 35mm stéréophonique. le niveau de sortie de cette prise ne permet pas l’utilisation d’un casque électrostatique. HEADPHONES The headphone terminal provides a stereo audio signal sufficient for driving all conventional stereo headphones except electrostatic headphones which generally require signal from a high level ouputs. L’accés aux autres menus et la validation de vos choix se fait façon identique How to use the multifunctions button Plug your preamplifier on the outlet, then switch ON the general power supply swich located on the rear panel. The voltage indicator will light on and the stand by button located on the front panel will light on in red. Push the standby button (front panel) and the light will become white, the left display indicate ADVANCE and the right display the level of the volume, then after a short time, the left display indicates the last selected source when the preamplifier was shut Off. At that time, you can select the different menus of your preamplifier. Push one time the center of the button and the left display indicates INPUT. Turn the button and you can choose a different source, push again the center of the button to confirm your choice. A > before the source indicate that your choice has been confirmed. WARNING You can eliminate this confirmation time by using the remote control Selections and confirmations of others menus and options work identically. These inputs are suitable for any line level source equipment such as tuners, CD players, DVD, MP3 players, etc. They should not be connected to the digital output of a CD player or any other digital device. PHONO INPUT AND GROUND TERMINAL You can connect your turntable on the RCA connectors left (L) and right (R). The output level of those pre-out can be adjusted by the volume button of your preamplifier. [. . . ] REC OUTPUT This analog audio input and output are for connecting a recorder with an analog audio input and output, such as a cassette deck, MD recorder, etc. And use the high quality DAC converter of your preamplifier in order to obtain a better sound result. USB INPUT Note: Do not turn on the unit until all connections have been made. Connect a USB ‘B–A’ cable from the preamplifier USB input to one of the USB ports on the PC or Mac. [. . . ]