User manual AUDIO DESIGN RX800A

[. . . ] For your own safness, commit the interconnexion and installation to your car audio retailer, where you have purchased the device. dISCONNECT THE GROUND CONNECTION FROM THE VEHICLE'S BATTERY BEFORE INSTALLATION. Before you start with the installation of the sound system, disconnect by any means the ground supply wire from the battery, to avoid any risk of electric shock and short circuits. [. . . ] This stands also for the equipped bass-remote wire, which should be installed not together with the power supply wires, but rather with the audio signal cables. Install all the wires and cables like described on the following pages, therewith these may not hinder the driver. Cables and wires which are installed close-by the steering wheel, gear lever or the brake pedal, may caught up and cause highly dangerous situations. The electrical wires should not be bared, to provide power supply to other devices. Never use for the installation or the ground point bolts and screw-nuts of the brake system, steering system or other security-relevant components. Otherwise fire hazard consists or the driving safety will be derogated. Do not install cables and wires not close-by movable objects like the seat rail or may be bended or harmed by sharp and barbed edges. If you lead a wire or cable through the hole in a metal sheet, protect the insulation with a rubber grommet. If objects like these will be swallowed, a risk of serious injuries consists. Consult promtly a medical doctor, if a child swallowed a small object. Before you start with the installation of the sound system, disconnect by any means the GROUND connection wire from the battery, to avoid any risk of electric shock and short circuits. BEFORE THE CONNECTION For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient profile section (at least 10 mm2), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove ruststreaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the installation, because loosely connections may cause malfunctions, unsufficient power supply or interferences. If you need to replace the factory-provided fuse observe by any means to keep the same fuse rating (7. For safety reasons the distance between the fuseblock and the battery must be shorter than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished. [. . . ] The LOW LEVEL INPUT RCA jacks must be connected with the RCA output jacks of the headunit. The OUTPUT LEVEL controller adjusts the output level and allows to match the level of the subwoofer with the complete sound system. The POWER LED lights up when the soundsystem is turned-on and ready for operation. [. . . ]