User manual AUTOTECH 10.998.230K

[. . . ] A U T O T E C H Installation Instructions www. autotech. com Part Number: Description: 10. 998. 230K; 10. 998. 232K SHOCK THERAPY® IGNITION WIRES, VR6 Notes: Since they will obviously not fit within the grooves made for the stock wires, Autotech's Shock Therapy® wires for VR6 engines use seven "T-clips" to hold the massive 10. 4mm diameter wires in position on the wire guide/engine cover. [. . . ] The short screws are used in the front engine bank's clips, the long screws in the rear bank's. Once the hole is made, you can select the proper length screw, depending on where the clip is located. Remove your stock wires ONE-AT-A-TIME, replacing each with a new Shock Therapy® wire before removing the next wire. This ensures that you maintain proper firing order (correct coil terminal to plug connection). Procedure: 1) Using the plug wire tool, remove the connector from one of the three front spark plugs. 2) Remove the wire from the wire guide by pulling gently upwards, and disconnect the wire from the coil. 3) Now match the length of the old wire to a new Shock Therapy® wire, and install the new wire. At this point, wait until the other two wires are in place before trying to mount any clips. [. . . ] 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 949. 240. 4000 Fax 949. 240. 0450 [. . . ]