User manual AUTOTECH 10.715.010K

[. . . ] Installation Instructions Part Number: 10. 715. 010K Description: Short Shift Kit for 5 speed Rabbit, Scirocco, & Jetta 1 Tools Required : Two ramps or jackstands Metric wrenches, 13 to 17mm Screwdriver Ruller or tape measure Moly grease Parts List: One Relay shaft One Selector lever One Selector shaft One Set of bushings Notes: This Short Shift Kit is selectable for shift reduction. [. . . ] Next, remove the standard relay shaft, selector lever, and selector shaft from the vehicle using the appropriate wrenches. When doing so, note the location of any bushings you remove so that they may be properly replaced when you are reassembling the linkage. Now fit the new linkage pieces into place using any new bushings that came with the short shift kit. Reattach the linkage selector rods making sure to lubricate the ball ends with moly grease. The only adjustment that may be required after the shift kit is installed is to the shift rod. The adjustment bolt is accessed from underneath the car where the shift lever and the shift rod connect. [. . . ] While the lever is in this position, dimension "A" at the top finger should be set to 15mm(see illustration) [. . . ]