User manual AXIS SPIN AX-2200 V2

[. . . ] Head guard floating heads assembly Your shaver is designed and manufactured to exacting standards in order to provide you with years of close, comfortable shaves. Feeling for your shaver It normally takes about three weeks for your skin to adjust to a new electric shaver. As you use your shaver, you will develop a shaving style that is most comfortable and effective for you. This "breaking in" period may be somewhat longer for those with sensitive skin or those who vary their shaving techniques. [. . . ] Amount of shaven hairs under the head and clean the entire head assembly when necessary, your shaver will always run at peak performance. Ensure that the floating heads and inner cutter assembly are not damaged. To obtain replacement parts, refer to the "Ordering Replacement Parts" section of this manual. Gently stretch the skin of your face with your free hand while moving the shaver slowly and smoothly against the grain of your beard. Hold the shaver at a 90° angle to your face while maintaining contact with the floating heads. To shave the chin area, gently pull the skin upward and slide the shaver in an easy upward motion. Remove the floating heads assembly by holding the body in one hand and pulling out the cutter assembly by the other. After washing, switch off the product, wipe dry with a soft cloth and leave it in an airy place until fully dried. Attach the floating heads assembly properly to the body to ensure smooth operation. 4 the body in one hand and pulling out the cutter Remove inner cutter assembly by pushing down and turning counter clockwise the srew knob in the center, then pull upwards away from the outer cutter assembly. If you routinely check the amount of shaver hairs under the head and clean the entire head assembly when necessary, your shaver will always run at peak performance. Make sure that the center knob is locked into place by pushing down and turning clockwise. After cleaning, always replace the plastic head guard to protect the floating heads. To maximize shaving comfort and closeness, periodically remove the head assembly to determine if your shaver needs cleaning, particularly if NOTE: To avoid damage, be sure to thoroughly wipe pre-shave lotion or shaver oil from the shaver's body. REPLACING THE BATTERIES If you use your shaver daily, the alkaline batteries will provide approximately 3 hours of shaving operation time. STORING THE SHAVER If the shaver is to remain unused for a long period of time, remove the batteries and store the unit in a cool, dry place. For optimum shaving performance and results, we recommends that you replace your shaver's floating heads and inner cutters once a year. To remove floating heads and inner cutter assembly To replace floating heads and inner cutters, please refer to the "Ordering Replacement Parts" section). Skin irritation or a deterioration of shaving performance typically indicates that your cutting heads need to be replaced. Replacement intervals will vary with individual use and different beard types. [. . . ] A purchase receipt or other proof of date of the original purchase is required for service and parts replacement under this warranty. Do not return the product to the retailer from whom this product was purchased. Contact AXIS / BPI toll-free at 1-877-263-9500 to obtain authorization during the warranty period to return the defective product by mail, postage prepaid. LIMITATIONS AND EXCLUSIONS There are no express warranties except as listed above. [. . . ]