User manual BELSON SD2001

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] Starting the dishwasher You have loaded your dishes and you now have to set the wash cycle. Interrupt the wash cycle by opening the appliance door with the utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it. The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "M". Open the dishwasher door, press the ON-OFF button as well, thus cutting off the electricity supply to the appliance. You can modify the wash cycle in progress, if it has If opening the only just started. Open door soon the appliance door after the end carefully to avoid any hot of the program, or water splashes, then during it, stand away keep button "P" pressed from the Dishwasher, for approximately 5 to avoid possible seconds, until you hear a injury from hot steam. Indicator light "M" will come off and at this point, all the settings will have been cancelled. Each time this button is pressed, one of the indicator lights "M" will come on in sequence, select the wash cycle you deem most suitable for the type of dishes to wash (take a look at page 7, where you will find the wash cycle table). Close the appliance door and after a few seconds, you will hear a short beep: the wash cycle has begun. The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. Us ARISTON DISHWASHER - User Manual 7 Water in your home Loading the salt. The salt container is situated underneath the lower rack, fill it up as follows: 1. Turn the appliance off at the ON-OFF button, turn on the water tap and wait approximately 20 seconds before turning the appliance back on; the selected wash cycle will start up again. Clogged filter alarm If the appliance is blocked and the 2nd and the 4th light from the right flash rapidly, this means the filter is clogged by large particles of food residue. Turn the appliance off, clean the filter thoroughly and reposition it in its seat as illustrated on page 10. If the 3rd light from the right flashes rapidly, turn the dishwasher off and back on again after one minute. If the alarm persists, first turn off the water tap to avoid any flooding and then cut off the electricity supply and call for technical assistance. Troubleshooting Limescale deposits or a white film form on the dishes. S Is the wash cycle suitable for the dishes you have placed inside the appliance?Your dishwasher is equipped with a safety system which is able to detect any operating problems. These anomalies are reported by one or two wash cycle indicator lights "M" will flash rapidly. [. . . ] When the wash cycle has ended, always remenber to leave the appliance door ajar. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. If there are any stains on the surface of the appliance interior, use a cloth dampened with water and a little white vinegar, or a cleaning product specifically made for dishwashers. [. . . ]