User manual BESTRON AAC9000

[. . . ] The appliance shall be stored in a well-ventilated area where the room size corresponds to the room area as specified for operation. Any person who is involved with working on or breaking into a refrigerant circuit should hold a current valid certificate from an industry-accredited assessment authority, which authorizes their competence to handle refrigerants safely in accordance with an industry recognized assessment specification. Servicing shall only be performed as recommended by the equipment manufacturer. If you pass this device on to someone else, you must include these operating instructions with the device. [. . . ] aTTENTION: · To prevent breaking, the exhaust host can only The maximal length of the exhaust hose is 150 cm. Do not use extensions or other exhaust hoses; this can cause serious malfunctions. If you have a tilt window instead of a sliding window, purchase a window sealing kit to close off your entire window airtight. The display (figure 1, A) indicated the The device starts functioning in the last used mode. When you turn the Device on for the first time, it is in the cooling mode. Aim the air stream right ahead, or slightly downward by manually setting the horizontal slats (4) in desired position. You can easily turn of move the device with the sturdy castor wheels to direct the airstream into the room. USAGE - Setting the mode The device has three operating modes, with which you can ventilate, dehumidify, and cool the room. Press the button "MODE" (figure 1, G), until the indication light lights up at "FAN". The device is now Press the button "SPEED" (D) to change between low or high speed exhaust air. The indication light lights Press the "SWING" button to activate the swing position. Press the button "MODE" (figure 1, G) once or multiple times, until the indication light lights up at "DEHUM". The device switches to the lowest speed, and will now dehumidify the air. Press the button "MODE" (figure 1, G) once or multiple times, until the indication light lights up at "COOL". The device is now functioning as an air cooler, and will cool the air by means of a cooling element. Use the buttons "UP" (E) and "DOWN" (F) to set the cooling temperature between 16°C and 31°C. Press the button "SPEED" (D) to switch between a low or high speed of exhaust air. The indication light lights up at "LOW" (low speed) and "HIGH" (high speed). aTTENTION: · When the internal water collection tray is full, the device stops functioning, and the indication light lights up on the control panel at "WATER FULL". You have to empty the water collection tray before you can continue using the device (see `CLEANING AND MAINTENANCE ­ Water drainage'). If you often use the device to dehumidify the air, you can also use the continuous drainage (see `CLEANING AND MAINTENANCE ­ Water drainage'). If you turn on this function, the device will operate in its most silent and energy saving mode. [. . . ] Any repairs carried out under the warranty will not extend the warranty period. Faulty parts, or in the event of exchange, the faulty equipment itself, will automatically become the pro- The warranty is valid for the first buyer only and is non-transferable. The warranty is not valid for damage caused by: Connection to a different mains voltage than indicated on the type plate · unauthorised changes · Repairs carried out by unqualified third parties · Use in violation with the applicable statutory, technical or safety standards · Careless transport without suitable packaging or other protection 6. warranty cannot be claimed: · For damage during transport · If the serial number of the appliance is removed or changed 7. [. . . ]