User manual BEURER IL 21

[. . . ] Observe the instructions for use Protect from moisture SN Serial number The CE labelling certifies that the product complies with the essential requirements of Directive 93/42/EEC on medical products. Note on important information Protection class II unit Note Caution: hot surface Warning instruction indicating a risk of injury or damage to health Safety note indicating possible damage to the unit/accessory Important 0, 8 0, 8 m 0, 8m 0, 8mm Manufacturer Disposal in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). Distance between infrared heat lamp and irradiated body part Warning 0, 6 0, 6 m 0, 8m 0, 8mm LOT Batch code The products must conform with Russian standards 7 3. €‚Notes Please read these instructions for use carefully and keep them for later use, be sure to make them accessible to other users and observe the information they contain. [. . . ] Make sure the appliance inot used by children without appropriate supervision. €¢ Keep children away from packaging materials (risk of suffocation). €¢ Do not cover up or pack away the unit while it is warm. €¢ Always remove the mains plug and let the unit cool off before you touch it. €¢  o not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the D unit. €¢ Do not pull the mains plug from the socket by the cord. €¢ In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power supply. If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised customer service technician in order to avoid hazard. €¢  isconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket. D •  here is a risk of strangulation for babies and children who become trapped in the mains cable. T Safety notes Warning • Product is not suitable for lighting rooms in private homes. €¢  his unit is not intended for commercial or clinical use, but only for individual, private household use!T • If you have health concerns of any kind, contact your general practitioner!€¢ Before you use the unit for the first time, remove all packaging materials. 8 General notes Important Repairs Important •  not open the device. €¢â€‚ If you need to have the unit repaired, contact customer service or an authorised dealer. Set the angle of the fluorescent screen in accordance with your individual requirements. Mains connection Connect the unit only to the mains voltage listed on the type plate. €¢ Ensure that there is a socket near the place where the lamp will stand. €¢ Lay the mains cable in such a way that no one can trip over it. Note: Replacing the fuse (UK plug only) If the fuse needs replacing, please observe the following: • Remove the mains plug • Lift out the fuse holder from the inside of the mains plug using a flat screwdriver •  ull out the fuse from the fuse holder and replace it with a new fuse type: 3A (breaking capacity 6 kA at 240 V) P in accordance with BS-1362 / SS167. €¢ Press the fuse holder containing the new fuse into the plug slot • Plug the mains plug into the socket and test to see if it works. [. . . ] Do Clean using a damp cloth, to which you can apply a little detergent if necessary. €¢  not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the Do unit. €¢  o not use abrasive detergents and never immerse the unit in water. €‚Disposal In the interest of protecting the environment, the unit must not be thrown out with the household waste at the end of its service life. [. . . ]