User manual BOWENS ESPRIT GEMINI 125

[. . . ] DO: Photocell Audio Ready Signal Recommended Modelling Lamps Weight SPECIFICATIONS Dimensions (w x l x h) Travel-Pak Compatible · Switch power off and disconnect from the supply before changing modelling bulb or flash tube. Protect from heavy, sharp or hot objects, which may cause damage and replace damaged cables immediately. · Due to the high voltage / high energy used in Esprit Gemini Units, all servicing must be carried out by an authorised Service Centre. [. . . ] Thanks to this handy battery pack, your Bowens Esprit Gemini Monoblocs can leave the studio to go on location anytime, anywhere!Able to power two monoblocs simultaneously with a total power of up to 1500Ws, the Travel-Pak is capable of bringing a 125Ws unit to full charge as fast as 1 second, and can offer in excess of 1, 000 flashes on a single charge. With a fast/slow charge option to prolong battery life as well as a stylish carry bag offering protection from the elements and up to 3 inches of water, no location photographer should be without this unique power pack. Dimensions (mm) - 180(l) x 120(w) x 175(h) Weight - 4. 1kg Travel-Pak (BW-7630) Also available for the Bowens Travel-Pak: BW-7635 Travel-Pak Boost Battery. BW-1227 Bowens Universal 2Amp SLA Charger. Ensure the power source is OFF. If using a battery source, ensure the connector locks are fully tightened. The unit will charge and indicate it is ready for use by illuminating the Green READY light. Press the TEST button to check the unit fires. Mounting Mount the Esprit Gemini unit on selected support system. The mounting bush on the 'L' bracket allows for two possible ways of mounting to the stand / support (Fig. 3). Method B may be found useful if the light is required to point down. Figure 3 A B 8 www. bowens. co. uk www. bowens. co. uk 5 Fitting the Modelling Lamp Switch off and disconnect from the supply. Screw modelling lamp into ES lampholder in the centre of the reflector. Note: It is recommended that a Photoflood or Halostar bulb with a maximum wattage of 275W is used. The manufacturer will not accept liability on the use of any lamp with a greater wattage than 275W. Modelling Lamp Control With the modelling lamp control switch (Fig. 1. With the modelling lamp set to the centre the modelling light will stay OFF, and with the switch set in the lower position the modelling lamp stays on FULL power. Fuse Flash Power Control The flash power output is variable over two f-stops from full to 1/4 power. [. . . ] Photocell: The Esprit Gemini has a built in switchable photocell enabling the unit to be triggered by the flash from any other flash unit or a small camera mounted flash gun. The photocell is mounted behind the red transparent cover on the top of the unit. The photocell on/off switch is located on the rear control panel. A range of reflectors is available for the Esprit Gemini unit. [. . . ]