User manual CABASSE MINORCA IW INSTALLATION

[. . . ] sAFETY INSTRUCTIONS Explanation of graphical symbols - The lightning flash With arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Power cords - The power cords must be laid out in such A way that they cannot be walked on, pinched, bent under other devices. Lightning - For better protection against lightning or if the device must remain unused for long stretches of time, unplug the power cord and antenna jack. [. . . ] Installation on a piece of furniture and stands - Do not place this device on an unsteady surface, i. Ventilation outlets - The device shall not be placed in a position that restrains the operation of its fans. Avoid installing the device on a bed, couch, blanket or other similar surfaces that may prevent the appropriate air flow. Do not install the device in a confined space, such as a book shelf or other piece of furniture, that could prevent sufficient air from flowing freely. Power - The device shall only be connected to a source of power compliant to the one described in this manual or on relevant printed labels on the product. If you are not sure of the type of power available, please contact your reseller or the local power company. Checks - After any servicing of the device, ask the technician to perform appropriate testing to make sure that the device works safely. exposure to high temperatures - The device should be Kept away from heating sources, such as radiators, heaters, amplifiers or any other similar item likely to make the operating temperature rise excessively. Plastic bags - Keep them away from children to prevent any After opening the top carton flaps, fold the carton flaps right back and invert the carton contents. remove the documentation , the grilles , the cutting template and the upper foam form , then get the speakers out. Keep the grilles away from the work area until you are ready to fit them. The grille has a paintable white semi-matte finish, ready if necessary to be re-finished to match your own decor. Turn off all the amplifiers before interconnecting them to the loudspeakers. In order to connect loudspeakers properly, it is most important to keep in mind the following two factors: cable section and phase. To get the full sonic potential of Cabasse loudspeakers and avoid power losses, the cables connecting the speakers to the power amplifier must have the lowest possible electrical resistance. Check that there is no conflict with other installations (pipe work, air conditioning, powercabling etc. In existing construction, use a stud-finding tool to map the construction accurately and a pipe detector to scan the proposed installation position. avoid installing the speakers in the same cavity as flimsy ducting , which may be induced to rattle. The speakers are designed to operate satisfactorily in a wide range of cavity volumes, ideally above 19 litres (0. Placement near a wall/ceiling junction or in a corner is to be avoided as it may give rise to too much bass and a boomy quality to the sound. [. . . ] A certain amount of flexing of the frame is allowed to take up unevenness in the mounting surface, but do not over tighten the screws as excessive distortion of the frame may occur. Because of technical improvements already under way in our constant search for optimum quality, Cabasse reserves the right to modify all the models presented in specification sheets, advertising materials and manuals without prior notice. This symbol on the product, consisting of the crossed-out wheeled bin, indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the disposal of electrical and electronic equipment at the end of life. [. . . ]