User manual CABASSE PACIFIC 3 SA INSTALLATION

[. . . ] Device on their own, except for those maintenance operations described in this manual. Any task beyond regular user maintenance must be performed by qualified service operators. Follow the instructions - Follow carefully all the installation and operation instructions. Troubleshooting - You must unplug your device from the Power supply and have it checked by a qualified technician if: The power supply or the plug is damaged. [. . . ] The tweeters of the speakers must be roughly at the same height of the listener's ear when the listener is in sitting position. No solid object or piece of furniture should be placed between the speakers and the listener. An effect of mask, even partial disturbs completely the sound reproduction as it attenuates the high frequencies and also, in most cases, the midrange frequencies. Unless designed for this application, bookshelf placement will alter the frequency response of the speaker, especially in the low frequencies. If a bookshelf location cannot be avoid, the speaker should be set up to minimize various resonance, and the visible part of the grille must be outside the niche. These accessories are to be screwed in the inserts on the base of the speakers after having removed the caps (turn them anti-clockwise). Adjust the height of the spikes by using the M4 Allen key delivered with the speakers. These accessories ensure the stability of the speaker while limiting resonance coming from certain types of grounds like wood floors. It is possible to use them without this front grille, by gently pulling its top end in order to cut off its magnetic link with the magnets to the front panel. To get the grill back in place, position it in front of the speaker and approach it to the front panel until the magnetic link is effective. These operations must be carried out very smoothly in order not to damage prematurely the veneer covering the magnets on the front panel of the speaker . Powerful drivers generate magnetic fields that can extend beyond the boundaries of the speaker cabinet. To get the full sonic potential of Cabasse loudspeakers and avoid power losses, the cables connecting the speakers to the power amplifier must have the lowest possible electrical resistance. To help you in choosing the minimum correct cable gauge, follow diagram. In order to maintain the phase relationship and frequency balance of the loudspeaker system, both loudspeakers must be properly connected to the power amplifier. When properly connected, the cones of the drivers of both loudspeakers will move in the same direction when driven by identical speakers will move in the same signals. If the cones move in opposite directions, the resulting out of phase signals will create a perceptible power loss, particularly in the low frequencies. In either case, always connect red or plus to red or plus and black or minus to black or minus. To check that the speakers are in correct phase, switch the system to mono while music is being played. If the amplifier does not have a phase inversion switch, it will be necessary to change over the connections on one only of the loudspeakers. If in correct phase, the image should be distinctly located between the loudspeakers with a slight loss of bass and low midrange level. If the image is confused and not centrally located and there is a drastic loss of bass and low midrange level, recheck your connections. [. . . ] Different ones will be profitable only when done by specialist using professional measurements equipment. 83V/1m) (dB) Cross-over points (Hz) Frequency response (Hz) Nominal impedance (ohms) Minimum impedance (ohms) Power handling (Watts) Pick power (Watts) Dimensions H x W x D Weight floor standing 3 1 x co-axial 2-way BC17 2 x 21ND34 91. Use a wet cotton waste for cleaning, or any cleaning device for wood or plastic. This symbol on the product, consisting of the crossed-out wheeled bin, indicates that this product shall not be treated as household waste. [. . . ]