User manual CABASSE XI SYSTEM

[. . . ] Front left and right speakers must be directed towards the listening area and placed on either side of the screen with at least a distance of 7 ft and 16 ft (2 and 5 m) between the 2 speakers. The centre satellite should be placed as close as possible to the screen: on the top, below, or directly on your television set. place the satellite at the vertical of the screen for a perfect cohesion and precision between dialogues and picture. Surround speakers should be placed against the side walls, at listening height or higher if possible and slightly behind the listening area. [. . . ] 2 Xi speakers + 1 Xi subwoofer (delivered with a MAX module and 2 CINCH cables) Connect each output of the amplifier directly to the matching Xi speaker: "FRONT LEFT" and "FRONT RIGHT". use the MAX module and one of the 2 CINCH cables for the connection of the subwoofer. Low frequencies coming from the 2 channels of your amplifier are taken directly from the amplifier with the MAX module and directed with one of the CINCH cable to the MAX IN input of the subwoofer. For the MAX module, cables are standardized; they can be connected to any speaker's outputs of the amplifier. It is absolutely necessary to respect the polarity (+/red, - /black) while connecting 2 of the 5 pairs of cables of the MAX in parallel with the speaker's cables connecting the amplifier to the Xi speakers. 2 Cabasse speakers + 3 Xi speakers + 1 Xi subwoofer (delivered with a MAX module and 2 CINCH cables) Connect each output of the audio video amplifier directly to the matching speaker: "FRONT LEFT" and "FRONT RIGHT" to your Cabasse speakers, "CENTRE", "SURROUND LEFT" and "SURROUND RIGHT" to the Xi speakers. use the MAX module and the 2 CINCH cables for the connection of the subwoofer. Low frequencies coming from the 3 channels "CENTRE", "SURROUND LEFT" and "SURROUND RIGHT" of your audio video amplifier are taken directly from the audio video amplifier with the MAX module and directed with one of the CINCH cable to the MAX IN input of the subwoofer. For the MAX module, cables are standardized; they can be connected to any speaker's outputs of the audio video amplifier. It is absolutely necessary to respect the polarity (+/red, - /black) while connecting 3 of the 5 pairs of cables of the MAX in parallel with the speaker's cables connecting the audio video amplifier to the Xi speakers. Then connect the input LFE IN of the subwoofer to the output SUBWOOFER/LFE of the audio video amplifier using the second CINCH cable. To avoid any electrical shock on the 3 left pairs of cable of the MAX insulates them from each other. To avoid any electrical shock on the 2 left pairs of cables of the MAX insulates them from each other. Ensure that each speaker is connected according to its position in the room. check that all the speakers are well in phase (+/red Caution in +/red and -/black in -/black). To prevent the risks Once this checking made you can of electric shock connect your amplifier and the takes care to completely insert plugs subwoofer to the sector. PHASE (located on the front): usually it is necessary to position the potentiometer on 0°, however 2 positions can be used 0° and 180 °. 1- Adjust the potentiometer on 0° when the subwoofer and the speakers are positioned at the same distance of the listening area. 2- Adjust the potentiometer on 180° when the subwoofer is positioned 5 ft (1. Setting your audio video amplifier The table below shows the adjustments to make. [. . . ] Do not use any sprays near the system or allow liquids to spill into any openings. Also, do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives. The grille assemblies on the speakers may be carefully vacuumed, if necessary. Please note that the drivers are located directly behind the grille cloth, and are easily damaged if reasonable care is not taken. [. . . ]