User manual CADILLAC SEVILLE 2002

[. . . ] Part Number 25729637 A First Edition ECopyright General Motors Corporation 06/14/01 All Rights Reserved i We support voluntary technician certification. GENERAL MOTORS, GM and the GM Emblem, CADILLAC, the CADILLAC Crest & Wreath and the name SEVILLE are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice. For vehicles first sold in Canada, substitute the name "General Motors of Canada Limited" for Cadillac Motor Car Division whenever it appears in this manual. [. . . ] Adjusting the Speakers (Balance/Fade) (Speaker): Press and release this button until the desired control (balance or fade) is found. - LEVEL +: After selecting the desired control, press the plus or minus symbol on this button to select the desired level. PTY (Program-Type): This button is inoperable on this radio. 3-14 RW (Rewind): Press the left arrow to rewind the tape rapidly. You may use your station pushbuttons to tune to another radio station while in rewind. FF (Fast Forward): Press the right arrow to fast forward to another part of the tape. You may use your station pushbuttons to tune to another radio station while in fast forward. Press the right arrow again to return to playing speed. % (Eject): Press this button to the right of the cassette tape player to remove a tape. Cassette Tape Messages If an error occurs while trying to play a cassette tape, it could be for one of the following reasons: & D The cassette tape is tight and the cassette player : Press the up or down arrow to seek to the next or previous selection on the tape. Your tape must have at least three seconds of silence between each selection for the SEEK arrows to work. The sound will mute while seeking. SCAN: Press this button to listen to selections for a few seconds. The tape will go to a selection, play for a few seconds, then go on to the next selection. SIDE: Press this button to change the side of the tape that is playing. SEEK cannot turn the hubs of the tape. Hold the cassette tape with the open end down and try turning the right hub counterclockwise with a pencil. If the hubs do not turn easily, your cassette tape may be damaged and should not be used in the player. (Check to see if your CLEAN TAPE: If this message appears on the display, the cassette tape player needs to be cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damage to the tapes and player. If any error occurs repeatedly or if an error can't be corrected, contact your dealer. 3-15 Playing a Compact Disc Insert a disc partway into the slot, label side up. If the ignition and the radio are on and the underlined compact disc symbol appears on the display, the disc will begin playing. Compact discs may be loaded with the radio off but they will not start playing until the radio is on. If you want to insert a disc when the ignition is off, first press the eject button. Full-size compact discs and the smaller compact discs are loaded in the same manner. If an error appears on the display, see "Compact Disc Messages" later in this section. RW (Rewind): Press and hold the left arrow to reverse the compact disc. [. . . ] This requires that you sign and complete a rental agreement and meet state, local and rental vehicle provider requirements. Requirements vary and may include minimum age requirements, insurance coverage, credit card, etc. You are responsible for fuel usage charges and may also be responsible for taxes, levies, usage fees, excessive mileage or rental usage beyond the completion of the repair. Generally it is not possible to provide a like-vehicle as a courtesy rental. Additional Program Information Courtesy Transportation is available during the Bumper-to-Bumper warranty coverage period, but it is not part of the New Vehicle Limited Warranty. A separate booklet entitled "Warranty and Owner Assistance Information" furnished with each new vehicle provides detailed warranty coverage information. [. . . ]