User manual CALIFONE CD-102

[. . . ] Place the center of the CD onto the spindle and gently press down to secure it in place. The Player will start playing with the LCD display showing the track number. When all of the tracks have been played, the player will automatically stop playing, unless programmed otherwise. Pause Mode To temporarily pause while the unit is playing, press the PLAY button once. The playing time in the LCD display will blink, indicating "Pause" mode. [. . . ] Press the STOP button to exit REPEAT mode or press the MODE button consecutively until no "alternative" method is indicated on the LCD. The LCD will indicate 1 ALL and the player will repeat playing the entire disc. Pressing the MODE button three times will return to the normal playing condition. Intro Mode The Intro Mode describes when the player will play the first 10 seconds of each track on the entire disk and will then automatically turn off. Press the MODE button three times and the LCD display will indicate "INTRO. " Then press the PLAY button and the "INTRO" mode will begin. The LCD will indicate "SHUFF. " Then press the PLAY button to begin. The player will play all tracks on the disc in random order until all tracks have been played. Press the MODE button once to exit RANDOM mode. 6 Automatic Start-Up/Shut Off Power On While in STOP mode, press the PLAY button. The Player will automatically start up and the display will indicate the start up sequence as shown in figure 1 (left). Auto Shut Off The Player will shut off automatically if no operation is selected within a one minute period after turning the CD Player on or after a disc has completed playing. If there is no disc in the unit, it will automatically shut off after approximately 30 seconds. "DISC" (no disc) Indication If there is no disc in the player or if a disc is not inserted correctly, the player will show "disc" on the LCD for approximately 30 seconds after pressing the PLAY button. 7 Shock Protection (ESP/Anti-Shock) Vibration Resistant By reading audio date and storing it in the "ANTI-SHOCK" memory, vibration resistance is achieved. When the player is bumped or knocked, the CD player will compensate with the data in its memory. The CD player also contains a vibration resistant mechanism to prevent the skipping noise caused by the change of playing speed when the player is "rocked". Auto ESP When pressing the PLAY button, the Anti-Shock System will automatically be enabled. When vibration continues, the in the display will turn into depending on the length of the vibration. To Cancel "ANTI-SHOCK" Press the ESP button, the in HOLD Function Moving the HOLD switch to the "On" position locks the unit, protecting it from an accidental pressing of another button while in use. the display will turn off 8 Charge Function (Optional) Charge Function 1. The CD Player will charge correctly sized rechargeable batteries (which are not supplied with the unit. ) Open the battery cover and insert the rechargeable batteries into the battery compartment, making sure the correct polarity as shown in diagram 1 (left) is observed. Continuously press FAST FORWARD, REWIND, NEXT & PREVIOUS FUNCTIONS. Press the REW/PREV button once quickly to skip backwards to the previous track or to the start of the current track. Press and hold the FF/NEXT button to fast forward through the current playing song. [. . . ] Caution 2 (left and right, stereo) 20-20000Hz >40dB Lower than measurement limit <10ESC <2dB 44. 1 KHz + - DC4. 5V 600mA 0-40 C 153*138*24. 5mm Unit No altering or remodeling This can cause malfunctioning. Locations to be avoided Avoid using the unit in the following locations. Do not leave the unit exposed to direct sunlight for long periods of time. This may deform or discolor the cabinet and may also cause malfunctioning. This product utilizes a laser. [. . . ]