User manual CATEYE CC-8000

[. . . ] If the icon now flashes, this indicates that the computer and sensor are too far apart or that the battery is low. ] Is the clearance between the sensor and magnet too great?(All Clear a ). Standard Parts #169-6590 Parts Kit ENG #169-6580 Speed Sensor A Wireless Sensor The sensor was designed to receive signals within a limited range to prevent sensor signal interference. If the temperature or battery power is low, they may need to be even closer than normal. [. . . ] If the temperature or battery power is low, they may need to be even closer than normal. The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. Install the computer on the stem, with its bottom surface facing the sensor. (Take into account the angle of the stem. ) Interference may occur, resulting in malfunction, if the computer is: · Near a TV, PC, radio, motor, or in a car or train. · Close to a railroad crossing, railway tracks, TV stations and or radar base. · Close to a second bicycle with wireless sensors. #169-6570 Bracket kit #169-9691 Wheel Magnet Replacing the Battery · Computer If the display appears faded or sensor reception is poor, replace the battery. Install a new lithium battery (CR2032) with the (+) side facing upward. Then re-start the computer according to the SETTING procedure, and then set the clock. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co. , Ltd. May void the user's authority to operate the equipment. Power-saving function If the computer has not received a signal for 10 minutes, power-saving mode will activate and only the clock will be displayed. When the computer receives a sensor signal again, the measuring screen reappears. If the unit remains inactive for two weeks, the unit enters SLEEP mode. Press the MODE button to stop SLEEP mode. LIMITED WARRANTY - 2-Year Computer/Sensor only Setting the clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Press the SET button to move from the "hour" to "minutes" digit. Press the SET button again to set the clock, and revert to the measuring screen. * If the unit of speed is set to km/h, the 24-hour time system is activated. [. . . ] Press the SET button to move from the "hour" to "minutes" digit. Press the SET button again to set the clock, and revert to the measuring screen. * If the unit of speed is set to km/h, the 24-hour time system is activated. [. . . ]