User manual CATEYE OS 1.1

[. . . ] OS1. 1SE-011025 066600151 1 E The position of the sensor and the magnet should be as shown: Side view Top view Bracket Wire Speed sensor Bracket band Sensor spacer Magnet Nylon tie Bracket screw (long) Sensor screw (short) Lithium battery (CR2032) Bracket rubber pad 5 Main Unit Fasten the screws securely 4 Bracket Remove Lever mark line less than 10 mm Align the center of the magnet and the sensor's mark line while rotating the wheel or crank. The clearance between the and the magnet sensor should be less than 10 mm. 3 Wire To remove 2 Speed Sensor Mounting View Front fork Push 1 Magnet Peel off Spoke Pull Caution!: Insure enough wire clearance in the area marked with to allow the handlebar to fully rotate without pulling the wire. Rubber pad C Mount · Names Liquid crystal display START/STOP button [ENTER button] MODE button [SELECT button (FWD/REV)] MENU button RESTART button Contacts Battery cover Setup If "YES" is selected · Custom Setup Select your favorite functions and preferred font size. [. . . ] Maximum Speed (Mx) and Total Distance (Odo) continue to be measured regardless of start/stop. 2 Format operation Format your unit before starting various setting. PRESS AND HOLD the two MODE/SELECT buttons, press and release RESTART button on the back of the OS. CONTINUE HOLDING DOWN the twoMODE/SELECT buttons for TWO MORE SECONDS and let go. Select YES and press ENTER/START/STOP button. ·Changing lower display EASY -------- 14inch~27inch CUSTOM --- 100~3999mm (See "Tire Size Calibration Chart" page 16. ) How to Use Countdown* Elapsed Time (Tm) Trip Distance (Dst) Counterclockwise Clockwise Clock Time 1 Installing battery CLOSE How buttons work in the SETUP process: OPEN Battery (CR2032) START/STOP button (ENTER) PRESSING FWD BUTTON: Moves to the right or increases the figure PRESSING REV BUTTON: Moves to the left or decreases the figure PRESSING BOTH FWD/REV BUTTONS: Goes back to the previous screen PRESSING ENTER BUTTON: Enters the figure and executes the selection · Icons on the screen 1 Screen 2 Battery life indicator 3 Selected tire icon 4 Auto mode icon 5 Speed scale icon 6 Pacer 7 Selected function icon Average Speed (Av) Totall Distance (Odo) Maximum Speed (Mx) * appears when the countdown function is on. [. . . ] (See "Countdown setting" page 15. ) ·Reset operation Press START/STOP/ENTER button and either of MODE/ SELECT button simultaneously, and the data other than Press simultaneously Total distance (Odo) and Clock Time is reset. REV FWD MODE button (SELECT) [. . . ]