User manual CATEYE V3 QUICK START

[. . . ] The purpose of this quick-start manual is to help you more easily navigate the new V3 (CCTR300TW) cyclo-computer. [. . . ] After you set the date/clock press the silver MENU button on back to proceed. Enter the tire circumference on the bicycle wheel in millimeters (tire size chart available in product manual or at www. cateye. com) Enter the last two digits of the tire circumference by using the M1/+ and M2/-. After choosing the tire circumference measurement press the silver MENU button on the back. Note: To complete the next step you must have the computer head unit, heart rate sensor, and speed sensor all within 5 meters of each other. (For further instructions on wearing heart rate sensor see page ENG-9 in owners manual. ) 9. While holding the computer head unit and wearing the heart rate sensor press the SSE button, once the head unit syncs with the heart rate sensor the screen will read ID-OK. Press SSE, then press SSE again, pass the magnet past the speed sensor "sensor zone" area until the screen reads ID-OK. To confirm press the silver MENU button on the back. The setup is now complete. Note: The data accumulated on a single ride can be zeroed out by pressing SSE and M2/- simultaneously then releasing the buttons. Operation Test ­ to test for proper installation and function of the speed/ cadence sensor follow these steps: 1. [. . . ] You will need to adjust the magnet sensor position to get the magnet within 5mm or less from the sensor pickup zones. [. . . ]