User manual CDA FWV900

[. . . ] This is normal, and the display will be corrected automatically once the appliance has run for a few hours. Use · Only store wine in sealed containers · Do not overload the cabinet · Only open the door when necessary · Do not cover the shelves with aluminium foil or anything else that will prevent air from circulating around the cabinet. · To prevent damage to the door seal, ensure the door is fully open before removing the shelves. · This appliance has been designed to work at an ambient temperature between 5º-38ºC. Use of the appliance outside of these parameters may cause the unit to fail. [. . . ] To use the internal light · Press the light button to switch the light on or off. Care and Cleaning Always disconnect the appliance from the mains electrical supply before any cleaning or maintenance. · Do not use abrasive products or detergents. · The exterior of the appliance and the door seal should be cleaned using mild soapy water and dried thoroughly. · The interior cabinet should be cleaned using a solution of bicarbonate of soda and lukewarm water. · Ensure that the cloth is only moist when cleaning the control panel and electrical parts, and that all water is thoroughly dried off before reconnecting the power. · Once cleaning is complete, reconnect the mains electrical supply. · If the appliance is not to be used for prolonged periods of time, unplug and clean the appliance thoroughly. The door should be left slightly ajar to prevent the formation of odours or condensation. Troubleshooting If you have any problems with your appliance, you should check the troubleshooting guide prior to calling CDA Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working, check · There is power to the appliance · The house fuses or circuit breakers are intact and the fuse in the plug has not blown. To check this, plug another electrical appliance in to see if the socket is working. The appliance is working, but not very well, check · The appliance is not overloaded. · · · · · The thermostat is set to an appropriate temperature. The door gasket is sealing properly There is enough ventilation at the side and rear walls. The ambient temperature is between 5-38ºC. The appliance is noisy, check · · · The appliance is level and stable. The cooling gas will make some noise, even when the compressor is not running. During operation, it is normal for the fan to run, even when the compressor is not running. The light does not work, check · · · There is power to the appliance The house fuses or circuit breakers are intact and the fuse in the plug has not blown. The light button is not set to off Please note: The LED lighting cannot be replaced without a service call. The door will not close properly, check · The appliance is level and stable. · If the door has been removed, it may not have been correctly refitted · The door seal is dirty · The shelves are not positioned correctly The display show "EL" or "EH" · The temperature sensor has failed Installing the wine cooler This appliance is intended to be built in to a kitchen cabinet. Below a hob unit Place your wine cooler in a location which is strong enough to support its weight when fully loaded. To level the wine cooler, adjust the front levelling legs at the bottom of the wine cooler. [. . . ] Unscrew the four lower hinge plate screws on the right hand side and the blanking screws on the lower left hand side. Remove the right lower hinge plate and rotate the hinge plate 180°. Refit the lower hinge plate on the lower left hand side using the four hinge plate screws, and then fit the blanking screws on the right. Rotate the door 180° and then relocate it on the upper and lower hinge plates. [. . . ]