User manual CDA RV921

[. . . ] This appliance must only be used for the purpose for which it is intended, i. Any other use could be dangerous and may lead to premature failure of the appliance. The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. [. . . ] When the correct time is shown on the display, the clock will set after approximately five seconds' delay. The minute minder The minute minder can be used when the oven is switched on or off. When the correct duration shows on the display, either touch or wait for approximately five seconds. The minute minder indicator will remain lit to confirm the minute minder is on. When the countdown is complete, there will be an alert beep which will continue for two minutes and the minute minder indicator will flash. Please note: At the end of the countdown, the minute minder will not switch off the oven. Semi-automatic cooking The main oven can be set to switch off automatically at a preset time up to a maximum of 10 hours. Then touch or to select the required duration for the semi- automatic cooking programme. When the correct duration shows on the display, wait for approximately five seconds. The cooking time indicator will remain lit to confirm the semi-automatic programme is on. Natural convection creates a perfect cooking zone in the centre of the oven, ideal for dark fruit cakes and pastries. W arming Oven T his setting uses heat produced only by the bottom element and is pre-set to 250°C. U sing only the top oven element pre-set at 250°C, this G rill This function radiates the heat from the grill element. Temperature Control Once the oven has reached the required temperature, the temperature indicator lamp on the control panel will switch off. The temperature indicator lamp will light up when the elements are working. Please note: Always ensure that you turn the control knob to its off position after you finish cooking. IMPORTANT: Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should always allow the cooker to cool fully after use before undertaking any cleaning or maintenance. Steam cleaners must not be used when cleaning this appliance · Clean the cooker regularly and remove spills as soon as they occur. Do not allow vinegar, coffee, milk, saltwater, lemon or tomato juice To remain in contact with enamel parts · do not use abrasive or corrosive cleaners (including scouring pads Or Cif) as these could scratch the appliance, remove control panel markings or damage the cooker. Do not clean the removable parts of the cooker in a dishwasher, these must be washed by hand. For the glass and stainless steel surfaces, you should use a nonabrasive cleaner. [. . . ] The CDA Group Ltd is not legally able to provide any assistance in the installation of gas appliances except to Gas Safe registered installers. Any Gas Safe registered fitter requiring help must provide their name, address and registration number. This appliance is suitable for conversion to Liquid Petroleum Gas (G30 Butane at a pressure of 28-30mbar or G31 Propane at a pressure of 37mbar). In the event that this appliance is not installed in accordance with the above requirements, the appliance may be disconnected from the mains gas supply until any faults are rectified; this is a legal requirement. [. . . ]