User manual CHICCO CHEERIO

[. . . ] Or escalators: you could suddenly Always pay attention when going up and down steps or pavements. If the stroller is left exposed to direct sunlight for an extended period of time, allow it to cool down before placing your child inside. Prolonged exposure to direct sunlight may cause the colour of the materials and fabric to fade. When not in use, the stroller should be kept out of reach of children. [. . . ] To avoid friction that may compromise the correct functioning of the stroller, make sure all plastic parts that run along the metal tubes are clean of dust, dirt and sand. ADJUSTING THE BACKREST The backrest can be adjusted to several positions. To recline the backrest, use the strap located on the rear; press On both sides of the clip and adjust the inclination to reach the desired position (Fig. To lift the backrest press on the clips and pull down on the strap (Fig. WARNING: The child's weight can make these operations more difficult. REAR BRAKES The rear wheels have linked brakes, which can be applied simultaneously on both rear wheels by using the support tube. To activate the brakes, press down on the pedal located centrally (Fig. To release the brakes, press the pedal in the opposite direction (Fig. WARNING: When opening the stroller, make sure that your child or To open and adjust the canopy use the front arch (Fig. WARNING: Make sure that during these operations the moving Parts of the stroller do not come into contact with your child. To remove the lining from the seat, follow the steps below: In the event that the bumper bar has Detach all the velcro fasteners and snap buttons that connect Been mounted on the stroller, after opening the frame reposition The backrest to the hood (Fig. 10) and remove the straps on both The bumper bar by rotating it forward until it locks in place (Fig. Sides from the plastic hooks that attach the backrest to the han- WARNING: Before use, ensure that the stroller is locked in the open On the sides of the seat, remove the velcro fasteners (Fig. Open the two velcro fasteners that bind the seat to the metal rod on the rear (Fig. The canopy can be removed: open the zip fastener that covers the tube above the backrest (Fig. 13) and free the arch from the joints on either side by pressing the button shown in figure 13 A and pulling up at the same time. Complete the operation by undoing the two buttons on the back of the backrest. To put the lining back on the stroller follow the same steps backwards. FOLDING THE STROLLER WARNING: When opening or closing the stroller, make sure that your child or other children are at a safe distance. Make sure that during these operations the moving parts of the stroller do not come into contact with your child. [. . . ] WARNING: When the rain cover is fitted on the stroller, never leave it exposed to direct sunlight with your child inside, as the temperature will rise considerably. WARRANTY The product is guaranteed against any conformity defect in normal conditions of use as provide d for by the instructions. The warranty shall not therefore apply in the case of damage caused by improper use, wear or accidental events. For the duration of the warranty on conformity defects please refer to the specific provisions of applicable national laws in the country of purchase, where appropriate. [. . . ]