User manual CHICCO ELETTA

[. . . ] • Never use this Child Car Seat on side-facing or rear-facing car seats. € Fit the Child Car Seat only in front-facing seats that are correctly secured in the car. Never leave folding or rotating car seats unsecured, they may be a source of danger in the event of an accident. € Pay attention when fitting the Child Car Seat into the car to avoid that a mobile car seat or car door may interfere with it. [. . . ] Only suitable if the vehicle is fitted with a 3-point static or 3-point retractor safety belt approved to UN/ECE Regulation No. If in doubt, consult either the child restraint manufacturer or the retailer. Please read carefully the following product and car seat use restrictions and requirements. Failure to comply with these instructions may affect the safety of your child. € This Child Car Seat is approved for use only for children between 0 and 18 kg of weight (from birth up to 3 years of age, approximately). € The car seat must be fitted with a 3-point static or 3-point retractor safety belt, approved to UNI/ECE No. Never fit the Child Car Seat to a seat that is only equipped with a 2-point safety belt (Diag. € The Child Car Seat may be fitted into the front passenger seat or any rear seat. Never use this Child Car Seat on side-facing or rear-facing car seats (Diag. € This product is expressly intended to be used only as a Child Car Seat; it should not be used indoors. hOW TO FIT THE CHILD CAR SEAT INTO THE CAR FOR GROUP 0+ (From 0 up to 13 kg) WARNING!When it is used for Group 0+ (from 0 up to 13 kg), always fit the Child Car Seat in a rearward-facing direction. If the front seat of the car is equipped with an airbag, deactivate the airbag before fitting the Child Car Seat. The points through which the safety belt must pass for fitting for Group 0+ (from 0 up to 13 kg) are highlighted in LIGHT BLUE. 6 – Adjust the Child Car Seat to the most reclined position with the handle K. 7 – Position the Child Car Seat on the car seat in a rearward-facing position. 9 – Tension the lap section of the belt as much as possible, and insert it inside the appropriate guide 7 O, located on the same side where you are fitting the Child Car Seat. 10 – Check that the Child Car Seat is tightly and correctly fitted into the car seat, and that the safety belt is well tensioned. If the Child Car Seat is not tightly and safely fitted into the car seat, repeat the installation. Always check that all parts of the safety belt are well tensioned and that it is not twisted. NEVER use the safety belt in positions other than those indicated in these instructions. hOW TO FIT THE CHILD CAR SEAT INTO THE CAR FOR GROUP 1 (From 9 up to 18 kg) WARNING! [. . . ] € Harness: Check that the fabric weft is not frayed or the harness strap worn out in the parts corresponding to the adjustment strap, crotch, shoulders and harness adjustment plate. € Plastic parts: Check that the plastic parts are not worn out, damaged or faded. If the Child Car Seat is deformed or worn out, it must be replaced: it may no longer comply with the original safety standards. STORING THE PRODUCT When it is not fitted into the car, it is recommended to store the Child Car Seat in a dry place, away from sources of heat and to protect it from dust, humidity and direct sunlight. [. . . ]