User manual CHICCO HOOPLA

[. . . ] €  ARNING: Do not use the reW clined cradle if any components are broken or missing. €  ARNING: Do not use accessories W or replacement parts other than those approved by the manufacturer. €  he product and all of its compoT nents must always be assembled by an adult. €  o not use the reclined cradle with D more than one child at time. [. . . ] This operation may also be carried out with the child sitting in the reclined cradle. WARNING: Always guide the backrest with the fingers when adjusting the reclining. To move from the highest inclined position to a lower inclination, just pull the backrest upward (Fig. WARNING: Always check that the backrest is properly locked before use. The reclined cradle is equipped with transport handles made of fabric. WARNING: The transport handles (I), when not used, shall be fixed on the back of the backrest with the velcro ribbons. The reclined cradle can be used in fixed or rocking mode: •  ixed mode: turn the front feet (B) clockwise until the lower part of F the foot touches the ground (Fig. 6); •  ocking mode: turn the front feet (B) in the opposite direction (counR ter-clockwise), so that the foot is not touching the ground (Fig. WARNING: The reclined cradle must never be closed with the child sitting in it.  o close the reclined cradle, press the 2 buttons inside the front T feet (Fig.  he safety harness is pre-fitted and ready for use the first time you T use the reclined cradle (Fig. To release it, press the toothed ends of the clasp and remove the two clasps (Fig. WARNING: When using, always remember to fasten the belt by passing it around the crotch strap and check it is tight enough and in the right position. It is possible to alter the tightness of the belt by adjusting it and passing the fabric around the back of the backrest.  eep one clasp end blocked and simultaneously pull the belt K and slide it inside the relative ring (O), to adjust the tension of the s BO 10 Po wit the (Fig TO 11 12.  he reducer cushion D - DD is ideal from birth and can be reT moved according to needs. To fix it to the seat, place it on the seat and slide the crotch strap through the hole (Fig. Thread the safety harness in the relative side slots of the reducer cushion (Fig. Position the headrest DD at the desired height; it can be chosen within three different heights; fix the headrest to the seat, sliding the straps through the slot and close it again using the velcro strap (Fig.  asten the toybar (E) to the frame inserting the lower ends in F the relevant fastening holes of the bar support (Fig.  he toys can be fixed to the toybar inserting the upper ends in the T relevant holes in the fabric bar (Fig. The toys can also be inserted in the two slider rings “F” on the arcs of the toybar (Fig. [. . . ] Of on 10/12 M, up to 18 Kg (CHAIR USE) •  ge range intended for use: from A when your child starts walking and is able to sit down and stand up by himself (about 10/12 months, max. €  ARNING: Before using as a chair, W remove the safety harness (crotch strap and waist belt) and position them in the relevant spaces. €  ägg inte till snören för att förlänga L upphängningarna på lekbågens hängande lekföremål och gör inga knutar/öglor: Det kan då oavsiktligt bildas löpknutar som kan medföra risk för strypning. €  lacér aldrig liggestolen i nærheP den af vinduer eller vægge, for at undgå risikoen for, at barnet kan læne sig ud og falde ned. [. . . ]