User manual CHICCO HOT HUMIDIFIER

[. . . ] Any other use is to be considered inappropriate and therefore dangerous. Artsana declines all responsibility for any damage caused by the inappropriate, incorrect or unreasonable use of the appliance. After removing any packaging materials, ensure that the humidifier is not damaged. In case of doubt, do not use and contact a qualified technician or your retailer. [. . . ] If the equipment is faulty and/or not working correctly, switch it off immediately and disconnect the plug from the mains socket. When the appliance is in use, always take great care and never remove the fastener screws on the lid cover. The appliance must be cleaned and dried thoroughly at the end of every cycle. If the appliance is not used for a long period, it must be stored as indicated in the Cleaning and Maintenance paragraph. When the appliance is no longer used, it is recommended to unplug it from the mains socket and remove the power cable. This appliance is not intended for use by people (children included) with reduced physical or mental capacities, or with insufficient experience or knowledge, unless they are under the supervision of a person responsible for their safety, or have been instructed on how to use the appliance. Children should be kept under adult supervision to ensure that they do not play with the appliance. To avoid the risk of fire, do not place the power cable under carpets or close to radiators, or gas and/or electrical heaters. Do not place the humidifier in rooms with very low temperatures (<5°C). The characteristics of this product may be modified at any time, without prior warning. F), making sure it is not directed towards people, furniture, curtains, walls, electrical appliances or objects that may be sensitive to heat, water and/or humidity. Attention: the steam flow will start to be released a few minutes after the appliance has been switched on. Attention: never approach your face or hands to the steam nozzle (4) or obstruct it with any objects. Attention: when the water in the tank runs out, the appliance will stop heating after a few minutes, the on/off button (1) will remain in the (I) position and the indicator LED will switch off. switch off the appliance by pressing the switch (1) to the (0) position (Diag. E), disconnect the plug from the power socket and refi ll the water tank as indicated in the Preliminary Operations paragraph. Attention: the appliance is fitted with an automatic device that switches off the heating element used to produce the steam when there is no water left in the tank. In order to start the steam dispenser again, you must first switch the device off and then back on again (1) Attention: if the indicator LED on the on/off switch (1) goes off, even when the on/off switch (1) is in the I position and there is water in the tank, this means there is a malfunction. Should this happen, do not use the appliance and contact one of Artsana S. Attention: never remove the lid cover unit (6) before switching off the appliance and disconnecting the power cable plug from the mains socket. Check that the lid cover unit (6) is fitted properly and locked in place by the fastener screws (7) on the tank (2), fill the tank with cold drinking or distilled water up the Max level(3) (Diag. 3) via the continuous water supply inlet (5), being very careful not to exceed the MAX level (3) indicated on the tank. [. . . ] How to Clean the Appliance Outer Surface Clean the appliance outer surface with a soft damp cloth. Do not use abrasive products, alcohol, solvents or similar products, which may cause permanent damage to the appliance outer surface. Do not place under running water or allow water to enter near the electrical parts . Should this happen, do not use the appliance and contact your retailer or one of Artsana S. [. . . ]