User manual CHICCO KEY 1 ISOFIX

[. . . ] The child car seat must be replaced if it is damaged, deformed, worn out or if any of its parts are missing, since it may no longer comply with the original safety standards. This product must not be modified or tampered with in any way, unless the modification is approved by the manufacturer. Do not install accessories, spare parts or components not supplied or approved of by the manufacturer. , either to distance the child car seat from the vehicle seat or to distance the child from the child car seat: in the event of an accident, the child car seat may not operate correctly. [. . . ] An unsecured child car seat may be a source of danger in the event of an accident or sudden braking. Artsana declines all responsibility for the incorrect use of this product or any use that does not follow these instructions carefully. It is intended for general use in vehicles, and it will fit most, but not all car seats. A correct fit is more likely if the vehicle manufacturer has declared that the vehicle is capable of accepting a "Universal" child restraint for this age group. This child restraint has been classified as "Universal" under more stringent conditions than those that were applied to earlier designs not displaying this notice. Only suitable if the vehicle is fitted with a 3point static or 3-point retractor safety belt, type approved to UN/ECE Regulation No. If in doubt, consult either the child restraint manufacturer or the retailer. Intended use of both item and vehicle seat, restrictions and requirements · Child car seat installation into the vehicle · Warnings for correct child car seat installation · Seating the child into the child car seat · Child car seat base frame K. Car safety belt horizontal strap guide Car safety belt diagonal strap lock clamp Installation instruction label Guide for inserting the diagonal part of the car safety belt Please read and observe the following instructions very carefully. Failure to comply with the instructions herein may affect your child's safety. ⷠThe child car seat is intended for children weighing between 9 kg and 18 kg. Insert the upper part of the diagonal belt inside the T guide, placing it exactly as shown in diagram 14. Pull the safety belt in the direction shown in diagram 14 firmly to tighten also the last part of the belt. Check overall installation to make sure that the child car seat is fitted correctly (Fig. To avoid safety hazards, after installation, ALWAYS check to make sure that: - the car safety belt is absolutely not twisted anywhere; - the car safety belt is correctly tensioned in all areas; - the child car seat is well locked onto the vehicle seat. If it is not, go through the whole installation procedure from the start. pLACING THE CHILD INTO THE CHILD CAR SEAT - Before seating the child , press the strap adjustment pushbutton. Simultaneously, take hold of the two child car seat straps below the shoulder pads and pull them towards you in order to loosen them (Fig. - Open buckle (G) on the child car seat belt, press on the red pushbutton (Fig. Always check to make sure that the child' back adheres correctly to the backrest (Fig. - Position the padded central lap harness correctly, take hold of the straps, overlap the two buckle tabs (Fig. 20-21) and push them very firmly inside the buckle housing so that there is a clearly audible "click" (Fig. [. . . ] Please check the care label for correct instructions on cleaning the seat fabric cover. Do not spin or tumble the fabric cover, simply leave it to dry without wringing. The cover is an integral part of the child car seat and therefore, subject to safety regulations, the fabric cover can be replaced only with another original fabric cover approved by the manufacturer. To prevent individual safety hazards, strictly never use the child car seat without its fabric cover. [. . . ]