User manual CHICCO KEY 2-3

[. . . ] Always use the child car seat, fitted correctly and with the safety harness fastened, including short journeys. Not using the child car seat constitutes a danger to your child's safety. In particular, check that the safety harness is tensioned correctly, is not twisted and that it is fastened in the correct position. An accident, even a minor incident, may cause damages to the child car seat, which are not visible to the naked eye: it is therefore necessary to replace the child car seat. [. . . ] Never use this child car seat on side-facing or rear-facing car According to car accident statistics, the rear seats of a car are generally safer than the front seat: it is therefore recommended to fit the child car seat into the rear seats of the car. In particular, the central rear seat is the safest, if it is fitted with a 3-point safety harness: in this event, it is recommended to fit the child car seat into the central rear seat of the car. If the child car seat is fitted in the front seat of the car, it is recommended to push the seat back as much as possible, bearing in mind the comfort of the passenger sitting in the seat directly behind it and to adjust the backrest in the most vertical position. If the car is equipped with a safety belt height adjuster, fix it in the lowest position, then check that the car seat safety belt adjuster is either in a backward position with respect to the backrest of the car seat (or at least aligned to it) (see diag. If the front seat is equipped with frontal airbag, it is recommended that you fit the child car seat into this seat. If you wish to fit the child car seat in any seat protected by airbag, always refer to the vehicle instructions manual. MAINTENANCE The cleaning and maintenance operations must only be carried out by an adult. How to Clean the Fabric cover The child car seat's fabric cover can be removed and cleaned. Please refer to the care label for instructions on cleaning the seat fabric. Clean the fabric cover only with a sponge, neutral detergent and water. The fabric cover can be replaced only with another fabric cover approved by the manufacturer, because it is an integral part of the child car seat and, therefore, it is a safety aspect. The child car seat must never be used without the fabric cover: it could be dangerous for your child. How to Clean the Plastic Parts Clean the plastic parts with a soft, damp cloth or a neutral detergent. Checking the Condition of the Components It is recommended to check regularly the condition of the following components to ensure that they are not worn out: · Fabric cover: Check that the padding does not come out from the seams. Plastic parts: Check that the plastic parts are not worn out, damaged or faded. If the child car seat is deformed or worn out, it must be replaced: it may no longer comply with the original safety standards. Storing the Product When it is not fitted into the car, it is recommended to store the child car seat in a dry place, away from sources of heat and to protect it from dust, humidity and direct sunlight. iNSTRUCTIONS Index · How to fit the child car seat into the car and place the child into the child car seat · How to remove the child from the child car seat. Reference circles How to Fit the Child Car Seat into the Car and Place the Child into the Child Car Seat. These instructions and diagrams are for the installation of the child car seat onto the right rear seat. To fit the child car seat in other positions, carry out the operations in the same order. Place the child car seat on the car seat, leaning the backrest against the backrest of the car's seat (diag. [. . . ] Pull out the seat inclination adjuster handle to the third position; following the instructions contained in the paragraph "How to Adjust the Inclination of the Backrest". Exercise some pressure onto the backrest towards its rear part, in the position where the joint is fitted to the seat, and release the two locking devices (diag. To fit the backrest onto the seat, repeat the operations described above in the reverse order. At the end of the above operations, check that the upper and lower parts of the seat are correctly locked to each other. [. . . ]