User manual CHICCO KIT TRIO CAR

[. . . ] After an accident, even a slight one, the carrycot and KIT TRIO CAR could have been damaged, even if this is not visible to the naked eye. They may have suffered structural damage, even if this is not visible to the naked eye. ARTSANA declines all responsibility for the incorrect use of this product. 04 series of amendments, for general use in vehicles and it will fit most, but not all car seats. [. . . ] Buckles for car safety belt To fasten the two buckles to the pins at the two ends of the carrycot (Fig. HOW TO FIT THE CARRYCOT IN THE CAR: FIRST TIME To fit the carrycot to the rear car seat, it must be placed in the middle and fastened by means of the safety belts of the two external seats (Fig. If the rear middle seat of your car has a 3-point safety belt, then the carrycot can be fitted also laterally taking up the middle and side places and fastened by means of the safety belts of these two seats. Remove and fasten the two car safety belts to their respective buckles (Fig. Never use he carrycot in the car with its backrest in an upright position!Carry out the following operations on both sides: - Hold the car safety belt and fold it to make an eyelet (Fig. 19) and turn the red bar back to its initial position, so that it passes through the eyelet (Fig. Pull the car safety belt towards the retractor, whilst at the same time pressing the carrycot against the seat, in order to fasten it securely (Fig. Join the two belt ends so that the belt adheres to the child's waist without being too tight (Fig. HOW TO UNFASTEN THE CARRYCOT FROM THE CAR SEAT Perform the following operations on both carrycot sides. unfasten the carrycot buckle by pulling the red tab of the buckle outwards and pushing the buckle upwards (Fig. Never use the car safety belt to fasten a passenger, without first removing the KIT TRIO CAR buckle: it could be dangerous!To remove the buckle from the car safety belt, loosen the belt eyelet (Fig. HOW TO FIT THE CARRYCOT IN THE CAR: AFTER THE FIRST TIME To fit the carrycot back to the seat, when the two buckles are already fastened to the car safety belts, perform the following operations. To fasten the buckles to the carrycot, read the instructions contained in the paragraph "HOW TO FIT KIT TRIO CAR TO THE CARRYCOT - Buckles for the car safety belt". Pull the car safety belt towards the retractor, while pressing the carrycot against the seat, in order to fit it properly (Fig. HOW TO REMOVE KIT TRIO CAR FROM THE CARRYCOT When you no longer wish to use the carrycot in the car, or if you wish to use it outside the car, KIT TRIO CAR can be removed as follows. Unthread the strap first from the left-hand slot by pulling it downwards and then from the right-hand one by pulling it upward (Fig. Buckles for the car seat belts Pull the red tab of the buckle outwards and push the buckle upwards (Fig. 28) HOW TO CLEAN THE PRODUCT Belt and buckles must be cleaned only by hand, using a damp cloth. [. . . ] In case of damage, do not use the product and keep it out of reach of children. When the child is not in the car, the carrycot must remain fitted in place or it should be stored in the trunk. ARTSANA declines all responsibility for the incorrect use of this product. Please contact Artsana's Customer Service for further information and to order any replacement parts: Postal address: ARTSANA SPA Servizio Clienti Via Saldarini Catelli n. [. . . ]