User manual CHICCO LULLABY LX

[. . . ] ⷠStop using the changing table when your child reaches 25 pounds (11. Before each use or assembly of product, inspect for damaged hardware, loose joints, missing parts or sharp edges. Although Chicco DOES NOT RECOMMEND refinishing this product, if you choose to refinish, use a nontoxic finish specified for children's products. aVOID SUFFOCATION HAZARDS: · To prevent suffocation from entrapment, use only the floor pad provided by manufacturer. [. . . ] If one or more of the top rails will not lock, pull sharply on center floor handle to make sure floor joint(s) are unlocked. Gently push down and lock two side lower hinges, located in the area of the two straps in the bottom of the playard. Fasten four end snaps (8A) and pull eight toggles through loops on the sides (8B). FALL HAZARD - Avoid death or serious injury from falling or sliding out: · Always use seat belt. ⷠAfter fastening buckle, adjust belt to get a snug fit around your child. ⷠAlways stay within arm's reach of your child when using the changing table. ⷠDo not use on the floor, bed, counter or other surfaces. ⷠDo not use changing table as a sleeping or play area. ⷠAlways remove the changing table when your child is in the playard. Attach both metal end pieces to poles, making sure metal spring button pushes completely through the holes. When using changing table, be sure to secure child with waist belt located on changing table. To fit the waist belt snugly, fasten the buckle together and pull tight on strap for a snug fit. If changing table is not secured, child in play yard can lift or shift changing table and get neck trapped between changing table and play yard frame. NOTE: All 4 buckles and the zipper must be securely fastened when changing table is in use. do not mix alkaline , standard (carbon-zinc) , or rechargeable (nickel-cadmium) batteries. Before attempting to operate the corner electronics unit, install four AA batteries matching the polarity indicated inside battery compartment. DO NOT use the electronics unless it is attached to the corner cap of the playard. The plus (+) sign increases volume and the minus (-) sign decreases volume. MANUAL ON: Slide the on-off switch to ON-6 position to enable activation of any mode for about 6 minutes. REMOTE ON: Slide the on-off switch to the REMOTE position to enable activation of any mode with REMOTE control unit. SOUND ACTIVATED ON: Slide the on-off switch to the ON-6 position to enable activation of both music and vibration with sudden sounds (i. The electronics unit will gently vibrate for about 6 minutes before automatically turning off. [. . . ] A sharp pull on the center floor handle will release floor locks allowing top rails to be unlocked. FLOOR JOINTS DO NOT UNLOCK: Raise center floor handle up to the level of the top rails to unlock floor joints. FOLDED PLAYARD DOES NOT FIT INTO FLOOR PAD AND ITS IS DIFFICULT TO ATTACH VELCRO: Pull center floor handle outward (toward corner caps) and push legs inward to compact playard. bASSINET DOES NOT FIT ONTO PLAYARD: Playard top rails must be fully upright and locked. [. . . ]