User manual CHICCO PROXIMA 1

[. . . ] The risk of serious injuries to the child increases, not only in the case of accidents, but also in other circumstances (i. ) if these instructions are not followed carefully: always check that the Child Car Seat is secured correctly to the car seat. If the Child Car Seat is damaged, deformed or worn out, it must be replaced: it may no longer comply with the original safety standards. This product must not be modified in any way, unless the modification is approved by the manufacturer. [. . . ] We recommend to consult your doctor, or the hospital's staff, to have a medical opinion on your child, and whether it can be carried in the Child Car Seat when leaving the hospital. Guide for inserting the diagonal section of the car safety belt (for both groups) P. This Child Car Seat is approved for "Group 0+/1", for the transport of children from birth up to 18 Kg of weight, and conforms to European norm ECE R 44/04. This Child Car Seat has been classified as "Universal", and can therefore be fitted into any car model. "Universal" means that it fits most, but not all, car seats. 04 series of amendments, for general use in vehicles, and it will fit most, but not all car seats. This child restraint has been classified as "Universal" under more stringent conditions than those that were applied to earlier designs not displaying this notice. Only suitable if the vehicle is fitted with a 3-point static or 3-point retractor safety belt approved to UN/ECE Regulation No. If in doubt, consult either the child restraint manufacturer or the retailer. Please read carefully the following product and car seat use restrictions and requirements. Failure to comply with these instructions may affect the safety of your child. 13 ­ Pass the horizontal section of the safety belt (lap section) under the two red belt guides M. 14 ­ Tension the safety belt as much as possible, holding it from the diagonal section (thoracic section). 15 ­ Press the button located on the locking clamp N, located on the side where you are fitting the child car seat; then insert the diagonal section of the belt into the clamp. Release the button, which will automatically return to the lock position. If necessary, carry out this operation exercising some pressure on the Child Car Seat with your knee. 18 ­ Check that the Child Car Seat is tightly and correctly fitted into the car seat, and that the safety belt is well tensioned. If the Child Car Seat is not tightly and safely fitted into the car seat, repeat the installation. Always check that all parts of the safety belt are well tensioned and that it is not twisted. NEVER use the safety belt in positions other than those indicated in these instructions. The safety harness must always be adjusted to suit the child's growth. 19 ­ To adjust the safety harness correctly, the straps must come out from the backrest, at the height of the child's shoulders. [. . . ] To remove the fabric cover, it is first necessary to remove the safety harness. 23 in the "HOW TO ADJUST THE HEIGHT OF THE SAFETY HARNESS" paragraph: Once the safety harness has been removed from the backrest: Diag. 34 ­ Take off the fabric cover from the seat of the Child Car Seat, removing the shoulder straps and the two harness straps from the respective holes, located on the fabric cover. to replace the fabric cover and harness straps , proceed as follows: Diag. [. . . ]