User manual CHICCO QUATTRO

[. . . ] Before use, check that the product and all of its components have not been damaged during transportation. Should any part be damaged, do not use and keep out of reach of children. Do not use the toy until all necessary maintenance has been carried out. Should any part be visibly damaged, do not use and keep out of reach of children. [. . . ] To fit the safety belt, slide it from the rear of the backrest through the openings, until the hook located at the end of the safety belt locks inside the hole. Pull the belt until a click is heard, indicating that it is locked into position (diag. To remove the safety belt, press on the tab, located at the end of the safety belt. This will release the tab and allow you to slide the belt from the hole located on the seat. Fit the seat as shown in diagram 4, locking the front part to the devices located in the car body (diag. 4-A), and maintaining the rear part raised, until it is safely locked into position. A-2) with a screwdriver, remove the hatch, remove flat batteries from the battery compartment, insert new batteries making sure the polarity is correct (as indicated on the product), replace the hatch and tighten the screw firmly. Use same or equivalent alkaline batteries as those recommended to operate this product. Always remove flat batteries from the product to avoid damages to the product by possible leakage. Always remove batteries in case the product is not used for long periods. Do not throw flat batteries into fire or disperse in the environment, but dispose through separate refuse collection. Should batteries leak, replace them immediately after cleaning the battery compartment and wash hands thoroughly in case they have come into contact with the leaking liquid. The use of rechargeable batteries is not recommended as they may decrease the toy's functionality. When using rechargeable batteries, remove them from the toy before recharging and recharge only under adult supervision. Fit the two armrests, first the right armrest (facing the toy from the front) and then the left armrest. Ensure that the front ring of the right armrest is placed under the front ring of the left armrest, as shown in diagram 6. The two identical, longer screws should be screwed into the rear housings (diag. 6-A), while the shorter screw should be screwed into the front housing (diag. It is recommended to carry out this operation with a coin, which should be kept out of reach of children after use. Turn the toy on one side, then proceed in the following order: fit the weighted bases into the appropriate housings; lock the weighted bases to the car body using the screws (indicated by an L in diag. [. . . ] After carrying out this operation, it is recommended to screw back the screws into the appropriate housings, located in the car body. For a correct and safe use of the product in this configuration, remove the product's seat belts. Use the toy in the Sit `n' Ride play mode only when the child is able to sit on its own. Never use the toy in the Sit `n' Ride play mode with the armrests assembled to avoid the overturning of the toy. [. . . ]