User manual CHICCO SIMPLICITY

[. . . ] €¢ It is recommended that the backrest should be used in its most reclined position for children from birth to 6 months of age. €¢ WARNING: With children younger than 6 months of age, always use the shoulder straps in the lowest position. €¢ WARNING: Before use, ensure that all the safety and locking devices are correctly engaged. In particular, ensure that the stroller is locked in the open position, by checking that the two sides are effectively locked. [. . . ] Regularly check the condition of the wheels and, keep them clean of dust and sand. To avoid friction that may prevent the correct operation of the stroller, ensure that all the movable plastic parts placed along the metal frame are clean of dust, dirt or sand. GENERAL INSTRUCTIONS HOW TO ASSEMBLE THE FRAME Before carrying out the assembly operations of the purchased product, it is recommended to open the stroller’s frame following the instructions shown in paragraph 7. Fit the footrest to the frame, locking it above the front horizontal bar (diag. Insert the support tube of the basket into the rear part of the stroller, as shown in diagram 2. Fit the front wheel unit to the stroller and lock it into position (see diag. A “click” will be heard indicating that the front wheel unit is fitted correctly into position. WARNING: Before use, ensure that the wheel units are safely locked into position HOW TO ASSEMBLE THE REAR WHEELS 4. des ieird den Der er- en , der hen ung orb or- den Ta- ten ei- bei un- on- den waass gente 5. To assemble each wheel to the rear axle E), insert the following components in the order indicated below (see diag. 5): ist, das chwie • The wheel A) • The washer B) • The cap C) • The cap cover D) Make sure that the locking clip is fitted as shown in the diagram: the straight side must be inserted into the slot located on the axis, while the closed end of the clip must face toward the external side of the stroller (diag. Insert the rear axle into the appropriate housings located on the frame, until a “click” is heard, indicating that the axle is locked correctly into position (see diag. WARNING: Before use, ensure that the rear axle is locked correctly into position. HOW TO OPEN THE STROLLER WARNING: When opening the stroller, ensure that your child, or other children, are at a safe distance. Ensure that during these operations the movable parts of the stroller do not come into contact with your child. Release the closing device located on the right side of the stroller and push the front part of the stroller forward, until a click is heard, indicating that the frame is locked correctly into position (diag. WARNING: Before use, ensure that the stroller is locked in the open position, by checking that the locking mechanism is effectively secured. To adjust the height of the stroller’s handle, press the 2 side buttons at the same time (diag. To fit the bumper bar, simply insert it into the two joints located at the ends of the armrest, as shown in diagram 9. To remove the bumper bar, push the two buttons located on the outer side of the bumper bar (diag. It is also possible to open the bumper bar from one side only, and turn it to place the baby on the seat more easily (diag. WARNING: The bumper bar must not be used to lift the product with the child inside. [. . . ] The stroller has a simple closing action that can be operated with one hand. To unlock the closing device: Press button A with your thumb, and then push it to the left, pressing button B at the same time, as shown in diagram 22. The locking device located on the right side will automatically lock the stroller in the closed position. ACCESSORIES: WARNING: The accessories described below may not be available for some versions of this product. [. . . ]