User manual CHICCO SIMPLICITY PLUS

[. . . ] Maintenance Lubricate the moving parts only if necessary, with a light application of a silicone based lubricant. Regularly check the condition of the wheels and, keep them clean of dust and sand. To avoid friction that may prevent the correct operation of the stroller, ensure that all the movable plastic parts placed along the metal frame are clean of dust, dirt or sand. Overloading, incorrect folding and the use of non-approved accessories may damage or break this vehicle. [. . . ] WARNING: When opening or closing the stroller, ensure that your Child is at a safe distance. Do not attempt to open or close the The cap cover D) Stroller with a child on board. Ensure that during these operations, Make sure that the locking clip is fitted as shown in the diagram: the The movable parts of the stroller do not come into contact with your Straight side must be inserted into the slot located on the axis, while the Closed end of the clip must face toward the external side of the stroller Always apply the brakes whenever the stroller is stationary. WARNING: Never leave the stroller on a sloped surface with a child Repeat the assembly operation with the other axle, in the same order. Do not let other children play unattended close to the stroller or Insert the rear axle into the appropriate housings located on the Frame, until a "click" is heard, indicating that the axle is locked To prevent the risk of choking, do not give to your child, or place near It, any objects with strings. WARNING: Before use, ensure that the rear axle is locked correctly into Do not use the stroller on stairs or elevators: it could cause the loss Pay special attention when manoeuvring the stroller up or down WARNING: When opening the stroller, ensure that your child, or other If the stroller is left exposed to direct sunlight for a long time, allow Children, are at a safe distance. Ensure that during these operations the It to cool before placing your child in it. Movable parts of the stroller do not come into contact with your child. Release the closing device located on the right side of the stroller Do not use the product if some of its parts are broken, torn or And push the front part of the stroller forward, until a click is heard, Indicating that the frame is locked correctly into position (diag. WARNING: When it is not used, the stroller must be kept away from WARNING: Before use, ensure that the stroller is locked in the open WARNING: The stroller must not be used while running or skating. To adjust the height of the stroller's handle, press the 2 side buttons To fit the hood, fasten the plastic clips to the tubes of the frame, At the same time (diag. 8), and adjust the handle to the desired Then fasten the Velcro straps in the appropriate positions, as shown WARNING: the hood must be fixed on both sides of the stroller. To fit the bumper bar, simply insert it into the two joints located at Open the hood as shown in diagram 20, and lock it by pressing down The ends of the armrest, as shown in diagram 9. To remove the bumper bar, push the two buttons located on the You wish to close the hood. The rear panel may be It is also possible to open the bumper bar from one side only, and Removed by unfastening the zip and opening the Velcro straps on the Turn it to place the baby on the seat more easily (diag. WARNING: The bumper bar must not be used to lift the product with WARNING: When closing the stroller, ensure that your child, or other Children, are kept at a safe distance. Ensure that during these operations This stroller has a 5-point safety harness that features two shoulder The moveable parts of the stroller do not come into contact with your Straps, two adjustment holes, a waist strap and a crotch strap with Before closing the stroller, also ensure that the storage basket is Empty and that the hood is closed. WARNING: When using the safety harness with children from birth up The stroller has a simple closing action that can be operated with one To approximately 6 months of age, it is necessary to first fit the shoulder Straps through the two adjustment holes on the fabric backrest. [. . . ] WARNING: Do not use the rain cover if the stroller is not fitted with To raise the backrest, simply push the seat back forward until the de- Sired position has been reached, without pressing the handle (diag. WARNING: The child's weight can make these operations more WARNING: When the rain cover is fitted to the stroller, never leave the stroller with the child onboard to prevent the risk of the child overheating. REAR BRAKES The rear wheels have linked brakes, which can be applied simultaneously To fit the legcover, slide it under the bumper bar and then fasten it with the Velcro straps, as shown in diagram 25. To apply the brakes, push the lever located at the centre of the rear To unlock the braking system, push the lever located at the centre of the rear axle , in an upward direction , as shown in diagram 16. [. . . ]