User manual CHICCO SOFT RELAX

[. . . ] After cleaning, check that the fabric and seams are not worn or damaged. ⷠWARNING: It is dangerous to put this bouncing chair on an elevated surface, such as tables, chairs, etc. ⷠWARNING: Not recommended for children who can sit up by themselves (6 months approximately; until 9kg). [. . . ] ⷠPlease refer to the care label for instructions on how to clean the product. ⷠAlways dry metal parts to avoid the formation of rust. COMPONENTS A ­ Rear legs B ­ Rear handle C ­ Pillow/Insert (Only on some versions) D ­ Carry handles E ­ Side joint to unlock the backrest F ­ Front joint to adjust the leg rest G ­ Crotch strap H ­ Legs I ­ Central button of safety harness buckle L ­ Safety harness prongs M ­ Velcro straps (Only for some versions) HOW TO ASSEMBLE THE PRODUCT Before use, the baby-bouncing chair requires a very simple assembly operation. Turn the legs (H) in an outward direction and fit the rear part (A) into legs' holes, pressing the locking buttons (diag. This operation may be carried out by fitting part A, in one way only, in order to prevent any assembly errors (diag. You will hear a click, signalling that part A has been fitted into position; ensure that the part has been fitted correctly by trying to pull it away from the frame (diag. Also, ensure that the carry handles (D) of the bouncing chair are facing outwards with respect to the legs; diagram 4 shows the correct position. When not in use, the carry handles (D) may be fastened to the backrest with the Velcro straps (M), diagram 5. If you wish to make the bouncing chair more compact, for example for car transport, it is sufficient to unlock part A, pressing the buttons highlighted in diagram 6. Unfasten the safety harness by pressing the central button on the buckle (I) and, at the same time, remove the other part of the buckle, by pressing its prongs (L) (diag. Always fasten the safety harness, inserting it through the crotch strap (G), and check that the harness fastens baby correctly and that it is adjusted/tensioned correctly (diag. 9) and recline the backrest to the desired position; lock the joints by turning them in the opposite direction (diag. This operation may be carried out with the child sitting in the bouncing chair, although it can be more difficult. HOW TO ADJUST THE FOOTREST The footrest can be adjusted to two positions. Low position: Press the buttons, located on the front joints (F), and, at the same time, push the footrest in a downward direction. ROCKING POSITION The baby chair can be used in the "rocking" position. [. . . ] CADDY ENJOY BOUNCING CHAIR The CADDY ENJOY range features fabrics with special colours, which are used with a wide range of Chicco Nursery products. For instructions on how to use the bouncing chair, please refer to this instructions booklet, with the exception of the "Pillow / Insert" section. For further information or spare parts requests, please contact Chicco UK Ltd Customer Service: Postal address: CHICCO UK LTD PROSPECT CLOSE KIRKBY IN ASHFIELD NOTTINGHAMSHIRE - NG17 7LF Telephone: 01623 750870 Website: www. [. . . ]