User manual CHICCO TOGETHER

[. . . ] €¢ WARNING: Ensure that all locking devices are engaged before use. In particular, make sure that the stroller is locked in the open 20 position, checking that the two side bars are locked in place. €¢ WARNING: Do not overload the basket with weights of over 5 kg. €¢ WARNING: Do not carry more than two children at a time. [. . . ] Check that the closing mechanism wire does not interfere with the carry-all tray fasteners. How to open the stroller WARNING: before you start, check that your children are at a safe distance. Ensure that during these operations the moving parts of the stroller do not come into contact with your child. Once the carry-all tray has been fastened to the frame, move the sliding button on the tray (diag. 2A) to the left whilst pressing the centre button and raising the handle (diag. 2B); now open the stroller by using your other hand to push the front section of the frame downwards, until you hear it click into place (diag. Make sure the stroller is open properly before proceeding any further. To adjust the height of the handlebar, press the two side buttons (diag. To assemble the basket, slide the U-shaped tube into the tube ends on the back of the stroller, as seen in diag. The U-shaped tube is fitted correctly when you see the 2 grey rods on the bottom, protruding from the holes below the stroller frame tubes and you hear them click into place. Never use the carry-all basket without the supports inserted properly. Always remove all contents from the basket before you close the stroller. Remove the caps from the ends of the rear axle, then slot the rear axle onto the frame, until you hear it click into place (diag. WARNING: always check the rear axle is fitted properly before using the stroller. To assemble the wheels on the rear axle A) follow the instructions in the correct order (see diag. 9A): - the wheel B) - the washer C) - the spring pin D) - the cap E) Make sure you insert the fastening spring pin as indicated in the diagram: the flat side must be inserted in the whole on the axle, whilst the closed end of the spring pin must be facing outwards (diag. Repeat the operation to assemble the other wheel, following the instructions in the same order. To assemble the bumper bar, simply slot it into the two holes on the ends of the front armrests, as seen in diag. To remove the bumper bar, press the two buttons found under the armrests, and pull the bar towards you (diag. To assemble the front hood, connect the hood fastener to the guides on the armrests (diag. To assemble the rear hood, connect the hood fastener to the round stopper on the rear stroller tube (diag. Warning: always release these two snap-bars before trying to close the hood. [. . . ] Please read the instructions relative to the accessories fitted on the type of stroller you purchased carefully. FULL-COVER RAIN HOOD WARNING: Pay particular attention when using the rain hood. To assemble the full-cover rain hood, thread the ties around the stroller tubes and close the ties and velcro fasteners in the positions indicated in diagram 33. When you have finished using the rain hood, allow it to dry properly if it is wet. [. . . ]