User manual CHICCO TRANSAT MIA

[. . . ] € WARNING: It is dangerous to use the reclined cradle on an elevated surface, such as tables, chairs, etc. € WARNING: Always use the restraint system when the child is in the bouncing chair; adjust the length of the straps as necessary. Should your child need to sleep, then it should be placed in a suitable cot or bed. € • WARNING: Do not use the reclined cradle if any components are broken or missing. [. . . ] € The cleaning and maintenance operations must only be carried out by an adult. € Periodically inspect the bouncing chair to check for broken, torn or missing parts: if this is the case, do not use it. € Please refer to the care label for instructions on cleaning the swing. Hand wash in cold water Do not bleach Do not use a dryer Do not iron Do not dry clean der nd on uss euen ell- AN DIE er- • Check that the fabric and stitching are in good condition each time you wash it. € Prolonged exposure to direct sunlight can cause the fabric to fade. Parts A – Legs B – Seat C – Booster cushion CC – Head rest D – Removable toy* E – Toy bar 13 ASSEMBLY The bouncing chair needs to be assembled before being used. Rotate the legs outwards and connect them to the seat as seen in Diagram 1. This operation can only be performed by inserting the legs in a specific direction to avoid errors. Check that the metal pin sticks out of the relative holes correctly (Diagram 2). You will hear it click into place; try and pull it out to make sure it is fitted correctly. Also make sure that the bouncing chair carrier handles are on the outside of the frame (diagram 3). The booster cushion C is ideal for use from birth and can be removed as required later on. To fasten it to the seat, place it on the seat and around the crotch strap as indicated in Diag. Position the head rest CC at the desired height, thread the strap through the slot on the chair and fasten in place using the velcro fastener as indicated in Diag. Fasten the toy bar on the structure, slotting it into the relative fixture. To fasten the toy D to the bar, thread the fabric strap through the slots on the top of the bar, paying ATTENTION that the closure of the velcro is facing downwards. Release the safety harness by pressing the centre button on the buckle and at the same part extract the other part of the buckle by pressing the prongs together (diagram 8). The bouncing chair is now ready for your baby When using the chair, remember to always fasten the harness straps threading them through the crotch strap and always check they are tight enough and in the right positionThe length of the harness straps can also be adjusted from behind the backrest. Take hold of one end of the buckle and then pull the strap to the desired length as seen in diagram 9. To adjust the backrest, turn the side fixtures (diagram 10) and raise/lower it to the desired position: block the side fixtures in place by turning them in the opposite direction (diagram 11). [. . . ] Remove the safety harness from the slots in the fabric and remove the slip cover from the front, starting from the foot-rest (diagram 16). Open the Velcro fastener underneath then slide the cover over the backrest. To refit the slip cover, proceed in the opposite order, paying ATTENTION that the lower fabric cord is threaded through the backrest adjustment fixtures (diagram 17). wARNING: REFIT THE SAFETY HARNESS MAKING SURE THE STRAPS ARE CORRECTLY THREADED THROUGH THE SLOTS IN THE FABRIC. [. . . ]