User manual CHICCO TRIO BEST FRIEND

[. . . ] Able, do not use the product and WARNING: Only use on a firm, keep out of reach of children. Before assembly, ensure that the WARNING: Do not let other children product and its components have Play unattended near the carry cot. Not been damaged during trans- WARNING: Do not use if any part portation. In this case, do not use Of the carry cot is broken, torn or and keep out of reach of children. [. . . ] The arch can be separated from the hood fabric by unfastening the two buttons that fix it to the fabric and pulling on one of the two ends (Fig. WARNING: Carefully store the removed arch, keeping it out of the reach of children. Always dry the metal parts to prevent the formation of rust if the stroller has come into contact with water. Put the carrycot cover into position and fix it into place WASHING The external/internal lining of the carrycot and the mattress are removable and washable; to remove them, please refer to the REMOVING THE CARRYCOT LINING section. For added protection, lift the fabric flap and fix it in place using the buttons on the hood (Fig. Refer to the instruction manual of the stroller for Details about the assembly of the leg cover configuration. The washing symbols and relative meanings are listed below: Wash by hand in cold water Before beginning the carrycot lining removal process, it is necessary to remove: - Cover, as outlined in point 4 - Car Kit 2013, put the lap belt into the holes in the mattress And the internal fabric of the carrycot. To remove the carrycot: - Remove the plastic flaps located in the head zone of the - Release the six elastic straps found on the external perim- eter of the carrycot (Fig. 5A) - By pulling upwards, remove the four prongs found in the Head zone of the upper edge of the carrycot (Fig. - Release the fabric from the pin located in the head zone 5D) by sliding it under the carrycot structure, then release the fabric from the pin in the foot zone (Fig. To replace the carrycot lining, repeat the steps illustrated Above in reverse order, using the images for removing the lining as guidance. - Insert the fabric beginning at the foot zone of the carrycot, being careful to stretch out the internal and external parts, keeping these separate (Fig. - Slide the fabric along the structure until it is in the front part and completely covers the frame of the carrycot. - Insert the elastic straps located on the side edge of the carrycot (Fig. 5A) and fix the prongs in the designated slots located on the rear edge in the head zone of the carrycot (Fig. - Complete the operation by inserting the plastic flaps of the internal lining between the plastic body and the Styrofoam absorbers (Fig. On the inside of the hood, between the visor and the first Section, there is a fabric ring with convenient hooks from which you can hang soft toys (fig. USING THE CARRYCOT AS A PRAM This carrycot can be used as a pram, but ONLY if mounted on the "BEST FRIEND" stroller. FASTENING THE CARRYCOT TO THE STROLLER To fasten the carrycot, it is necessary to remove the stroller seat or the child car seat if present. Hold the handle in transport position and attach the Carrycot to the fasteners at the side of the stroller with the foot zone facing the handle of the stroller (Fig. [. . . ] 11 ); to put the handle back in the rest position, press both buttons at the base of the handle at the same time and then turn the handle downwards (fig. WARNING: Do not transport the carrycot with the handle in middle or rest position, but only with the handle in carrying position. Liggkorgens lock kan även omvandlas till fotsack för sittvagnen. Hold liftens og klapvognens fastkoblingspunkter rene for støv og sand, for at undgå friktion. [. . . ]