User manual CHICCO URBAN

[. . . ] ⷠAfter removal of the safety harness 22 ensure that the harness is reassembled correctly using the anchorage points. To ensure that the harness is adjusted correctly, fitting your child and securely closed, pull firmly on the end of the harness. ⷠWith the car seat fitted into the stroller, it does not in any way replace a cot or bed. If the child needs to sleep, they should be placed in a carrycot, crib or bed. [. . . ] WARNING: Before using the stroller, make sure that the wheels are well secured to the structure. Assemble the basket positioning the shaped part on the front tube, using the relative press stud buttons (fig. To complete the assembly, thread the straps located on the front part of the basket through the ‘’D’’shaped rings located on the front legs of the stroller, securing the straps with the press stud buttons (fig. To assemble the seat, position the metal support located on the base of the seat as shown in fig. Then close the zip located at the bottom of the seat, wrapping the metal component (fig. Fasten buckle A located externally in the seat’s foot area, as shown in Fig. 8 in the relative slots located inside the circular articulated joints of the stroller (fig. The seat can be assembled on the stroller in both directions: in forward facing configuration (Fig. These operations must not be performed when the child is inside the seat. WARNING: Do not remove the seat from the stroller when the child is inside of it. SEAT ADJUSTMENTS Once the seat is assembled on the frame, it can be adjusted in three different positions. The entire seat can be adjusted by pressing simultaneously the buttons located above the central articulated joint (fig. The angle of the backrest can be adjusted compared to the seat, by pressing the clip as shown in fig. It is possible to adjust the leg rest in various positions, by pressing simultaneously the buttons shown in fig. The rings are located inside the stroller’s seat on the right and left side, as shown in (fig. REMOVING THE SAFETY BELTS The safety belts can be removed (to be washed or used in pram configuration). To remove the belts, unfasten the waist belt from the relative ‘’D’’-shaped rings and the shoulder straps from the fabric slots located on the backrest. After removing the safety belts, make sure that the belts are reassembled properly using the anchoring points. To re-assemble the safety belts systems, follow the sequence below carefully: 22. 21), making sure that the length adjuster is positioned as shown in (fig. Take the plastic slot end of the shoulder strap and introduce it into the safety belt’s fabric ring (Fig. After performing this operation properly, pull the belt downward until the fabric ring is turned inside out (fig. [. . . ] The ‘’Colour Pack’’ includes a comfort kit containing 2 shoulder strap pads (A), a crotch strap cover pad (B) (fig. For assembly, thread the shoulder straps in the slots as shown in (fig. The shoulder straps can be adjusted according to your child’s size. 41A) can be used in two different ways: as legcover in stroller configuration (fig. [. . . ]