User manual CHICCO WALKER

[. . . ] A Multifunction Toy: When the toy is in the WORDS mode, the child will listen to the letters of the alphabet, numbers, colours, the opposites, the name of surfaces . When the toy is in the MUSIC mode, the child will enjoy listening to melodies, nursery rhymes and sounds. The child can explore both play modes in its own mother tongue or in a foreign language. The toy can also be used in the TABLE mode, standing up, or in the ACTIVITY CENTRE mode, sitting on the floor. [. . . ] To remove the legs from their housings, hold each leg and pull towards you. The large flower (3), located in the number area, can be removed from its support (4). to replace the flower , hold the stem with one hand and insert the flower , as shown in diagram B. The stem of the flower can be fitted in two positions (high and low), and it will create a fun "growth" effect when the child presses the watering can button. how to Switch on the Toy and Select the Play Modes · To switch on the toy, move the switch (5) from the OFF position to the <))/<))) position, depending on the desired volume level. A short melody followed by the invitation to play confirms that the toy is switched on. after switching on the toy , all the electronic activities will be activated. After a short time of non-use, the toy says goodbye to the child and goes in the stand-by mode, until the child presses one of the activities again. To avoid wasting battery power, it is recommended to always switch off the toy, moving the switch (5) to the OFF position. When the toy is switched on, it is pre-set on the mother tongue mode. The language mode can be changed by pressing the appropriate button (6) marked by the corresponding writing. bUTTERFLY: When the child presses the wings of the butterfly (13) , it will listen to a melody and to the animal's name. If it turns the central wing of the butterfly as if it was the page of a book, it will listen to a fun nursery rhyme and a sound effect. To replace spent batteries: Loosen the screw on the battery compartment cover, located under the activity centre (14), with a screwdriver and open the cover. Then remove the spent batteries and fit new ones, ensuring that they have been fitted in the correct polarity (as shown on the product), close the battery cover, and tighten the screw. Always remove spent batteries from the toy to avoid the danger of leakage from the battery damaging the product. Always remove the batteries if the toy will not be used for a long period of time. Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function of this product. Do not attempt to recharge non-rechargeable batteries, they might explode. The use of rechargeable batteries is not recommended, since they might impair the toy's functionality. If rechargeable batteries are used, remove them from the toy before recharging; this operation must be carried out only under adult supervision. The crossed bin symbol on the appliance indicates that the product, at the end of its life, must be disposed of separately from domestic waste, either by taking it to a separate waste disposal site for electric and electronic appliances or by returning it to your dealer when you buy another similar appliance. [. . . ] For further information regarding the waste disposal services available, contact your local waste disposal agency or the shop where you bought the appliance. THIS PRODUCT COMPLIES WITH EC DIRECTIVE 2006/66/EC The crossed bin symbol on the batteries or product pack indicates that, at the end of their life, they must not be disposed of as urban refuse. They must be disposed of separately from domestic waste, either by taking them to a separate waste disposal site for batteries or by returning them to your dealer when you buy similar rechargeable or non-rechargeable batteries. the chemical symbols Hg , Cd , Pb , printed under the crossed bin symbol , indicate the type of substance contained in the batteries: Hg=Mercury , Cd=Cadmium , Pb=Led. [. . . ]