User manual CHICCO XPACE ISOFIX

[. . . ] IMPORTANT WARNING: Fitting the Child Car Seat with the ISOFIX System 1. It is approved to ECE R44/04 Regulation, for general use in vehicles equipped with ISOFIX safety systems. To use the UNIVERSAL ISOFIX system, it is necessary to read the instructions booklet of the vehicle before fitting the child car seat into the car. The instructions booklet will indicate the seats compatible with the class and age group of the child car seat approved to the UNIVERSAL ISOFIX system. [. . . ] It is not recommended to fit the child car seat into a front seat equipped with airbag. If you wish to fit the child car seat in any seat protected by airbag, always refer to the vehicle instructions manual. Never fit the child car seat to a seat that is only equipped with a horizontal 2-point safety belt (diag. While keeping the handle pulled, pull out the ISOFIX system COMPLETELY from the rear of the backrest (diag. 11a) and, while keeping them pressed down, remove the two protective caps (X) (diag. Place the two caps into the appropriate housings, located under the base (diagrams 12a - 12b). Store the caps in a safe place, since they are indispensable for reinserting the ISOFIX system inside the base when the system is not in use. Check that there are no loose objects between the child car seat and the car seat or between the child car seat and the door of the car. Insert the two ISOFIX connectors into the corresponding ISOFIX locking devices, located on the car seat, between the backrest and the seat (diag. Ensure that the two ISOFIX connectors are locked correctly into position, checking that the two (Z) signs are green. Push the child car seat firmly against the backrest of the car seat (diag. HOW TO FIT THE TOP TETHER The installation of the child car seat is complete only by fitting the Top Tether. Pease refer to the instructions booklet of the vehicle to identify the locking point of the Top Tether of the child car seat. 15), and it may be located in the positions indicated in the diagrams 16a – 16b – 16c – 16d – 16e. Do not mistake the locking device of the Top Tether with the ring provided for securing the luggage (diag. Insert the Top Tether between the top part of the backrest of the car seat and the headrest. After identifying the locking point, connect the hook (DD) of the Top Tether (diag. Adjust the length of the Top Tether belt, pulling the strap firmly to tension it correctly (diag. The belt is tensioned correctly when the indicator located on the strap is green (diag. Roll up the excess strap and fix it with the specific Velcro strap provided (diag. Remove the child from the child car seat before proceeding to the removal of the ISOFIX system. Roll up the Top Tether strap and fix it with the appropriate Velcro strap (diag. [. . . ] - open the fabric cover velcro fastener on the  interior of the backrest (Diag. - push the harness strap, together with the  shoulder strap, under the cover (Diag. R - remove the headrest cover, the crotch strap and the child car seat cover. To replace the fabric cover and safety harness, proceed as follows: - replace the headrest cover, the crotch strap  and the child car seat cover. [. . . ]