User manual CLASSE AUDIO CDP 1.5

[. . . ] 13 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 3 UNPACKING & SET-UP WARNING THE CDP-1. 5 IS NOT TO BE OPERATED WITH THE COVER OPENED. To prevent fire or shock hazard, do not expose this product to rain or moisture. HEAT: This product should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances which produces heat. [. . . ] Pressing it sequentially will cause the CDP-1. 5 to go back one track each time it is pressed. This button is also used to select tracks to play and program into memory. NEXT( ): Each time this button is pressed, the CDP-1. 5 will advance one track i. e. If pressed during playback, the CDP-1. 5 resumes playing from the desired track. FORWARD(») AND REVERSE(«) SEARCH: The CDP-1. 5 employs a convenient 2-speed search. These buttons allow you to quickly search through the disk in both directions. The time counter will approximately double in speed, and the track heard will be reduced in volume. Once the desired point is reached, release the SEARCH button, playback will resume. If the SEARCH button is held for more than 4 seconds, the CDP-1. 5 goes into a high-speed search mode, and the time counter advances very rapidly. During high-speed search, the volume is completely muted. 8 In addition to all the above functions, the remote handset of the CDP-1. 5 contains the following additional functions. NUMERIC KEYPAD (digits 0 through 9):This is a convenient alternative to the PREVIOUS and NEXT buttons. Pressing the desired track number on the numeric keypad is usually faster than the PREVIOUS and NEXT buttons. For example, if you just inserted a disk and wish to play track 8, pressing 8 followed by PLAY is easier than pressing the NEXT button eight times, and then PLAY. REPEAT: Repeats the whole disk, the programmed tracks or just the single track being heard. CLEAR: Will clear the last track entered into memory. DISPLAY: When pressed once, the display will count backwards giving the total remaining time on the disc or the programmed tracks. If pressed once more, the display will count upwards the total time on the disc or the programmed tracks. If pressed once again, the display will return to its normal function. NOTE: There is no variable output on the CDP-1. 5. 2. DISPLAY INFORMATION AND VARIOUS MODES OF OPERATION: To insert a disk, press LOAD to open the CD tray. Gently place the disk with the label side up on the tray, and press LOAD again, the tray will close, and several seconds later the display will indicate the total number of tracks on the disk with the total playing time. If the disk has not been properly inserted, or is inserted upside down, ZERO's (0 0 00) will appear on the display. Disks with bad scratches, pinholes, or other severe manufacturing defects might also not be useable. Once the display confirms the number of tracks and playing time, the CDP-1. 5 is in STOP mode. Playback from the beginning or from a selected track To play an entire disk from the beginning, press PLAY. [. . . ] Every unit has to pass more than 100 separate tests before leaving the factory. 15 CLASSÉ CDP-1. 5 COMPACT DISK PLAYER SPECIFICATIONS: Wow and Flutter Jitter Digital outputs: Below measurement level Below measurement level SINGLE-ENDED on RCA connector and AES/EBU on XLR connector 75 ohms, 0. 5 Volt peak to peak output DC to 20 Khz, + 0. 1 dB. -108 dB typical Burr Brown 1704 24 bit 16 bit linear Better than -90dB @ 1Khz Better than -115 dB @ 1Khz Better than ± 0. 005 VDC Less than 50 picoseconds RMS, 20Hz to 40Khz GaAIAs, 0. 5 mw, continuous, 790 nm 352. 8 Khz 200-500 rpm (constant linear velocity) 16 bits linear CIRC principle 2 channels, stereo Frequency response Signal to noise D/A Dynamic range THD+N Channel separation Offset voltage Clock Jitter Laser semiconductor Sampling rate Disc rotation velocity Quantization Error correction Number of channels POWER REQUIREMENTS: Europe/UK Canada/USA/Japan WEIGHT AND DIMENSIONS: Dimensions: Gross: Net: Weight: Gross: Net: Operating temperature Storage temperature Operating position 180-260 VAC, 50 Hz, 18 Watts typ. 90-130 VAC, 60 Hz, 18 Watts typ. 24"x 21 1/4" x 10 1/4 19" x 12 7/8" x 3 3/4" (W x D x H) 28 lbs. 0ºC to + 40ºC -20ºC to + 60ºC Horizontal, up to +5º inclination in any direction. 16 CLASSÉ AUDIO 5070 Francois-Cusson Lachine, Québec Canada H8T 1B3 Telephone: 514 636 6384 Fax: 514 636 1428 E Mail: cservice@classeaudio. com Website: classeaudio. com 17 Notice to all Classé Product owners: Thank you for your purchase of a Classé Audio component. [. . . ]