User manual CLATRONIC MRC 485 RC 2

[. . . ] Assemble the device in such a way that the available ventilation openings are not covered. Should the device become damaged, in particular the mains supply cable, do not operate the device any longer, but rather have it repaired by an expert. For safety reasons a broken or damaged mains lead may only be replaced by an equivalent lead from the manufacturer, our customer service department or a similary qualified person. [. . . ] After a few minutes the time data is taken automatically from the broadcasting station. The time is reset automatically every 12 hours via the broadcasting signal. Should the time not be correct even after a long operating period, you can start the automatic reset also by pressing the relevant button. ATTENTION: Reception in a radius of 1500 km from Franfurt/Main should be trouble-free. However, disturbances may occur owing to the local reception position. Buildings with tall metal elements and the vicinity of TV sets, PC's, cell phones, etc. If the automatic setting is still not possible after 20 minutes despite the alignment of the incorporated antenna, the reception position is too bad. Select the time zone where you are located (Germany = MUN) with the buttons (1 or 2). Display Mode You can choose which information to show on the display, i. To select a display mode, press the SHOW button (2) as many times it is needed to show the desired setting on the display (13). In FM mode you can improve reception by using the extensible antenna (9). To direct this antenna, turn the radio or choose a different position to improve the quality of reception. Press the SNOOZE button (12) to select the day when you wish to be awaken. "AL2" appears again on the display and the time starts to flash. Once the alarm times are set and a radio station has been selected, shift the function selector to "AUTO". If you wish to not be waked up with the radio, you can turn the volume knob all the way to the left until you hear it snap. [. . . ] The replacement and repair will not be performed free of charge without this proof of purchase. Should the warranty be valid, please consign the complete appliance in its original packing together with the cash receipt to your local dealer. Motor pistons, kneading hooks, drive belts, spare remote controls, spare toothbrushes, saw blades, etc. [. . . ]