User manual CLATRONIC MRC 498 DT 2

[. . . ] Assemble the device in such a way that the available ventilation openings are not covered. Should the device become damaged, in particular the mains supply cable, do not operate the device any longer, but rather have it repaired by an expert. For safety reasons a broken or damaged mains lead may only be replaced by an equivalent lead from the manufacturer, our customer service department or a similary qualified person. [. . . ] If you would prefer to hang the clock radio on the wall, an indentation is provided for this on the back. Turn the function switch on the left side of the machine to the ON position. The desired volume can be set with the volume control (1) on the right-hand side of the clock radio. If you would like to switch off the radio, move the RADIO/ON/OFF/ALARM/AUTO button (8) to the OFF position. Hours: Keep the TIME button (10) on the back of the machine pressed down until the hour display begins to flash. Then press the +/- buttons (11/12) on the back of the clock radio until the desired hour has been reached. When the TIME button is pressed again, it is possible to set the month and the date. To change from one system to the other, press the +/12/24 hour button. If no button is pressed within 15 seconds, the machine automatically switches back to the normal time display. An integrated sensor reads the temperature and displays it in the bottom right-hand corner of the display. This can be changed from Celsius (°C) to Fahrenheit (°F) by pressing the -/°C/°F TEMP button (12). Then press the +/12/24 hour button (11) in order to go forwards or the -/°C/°F TEMP button (12) in order to go backwards until the desired hour has been reached. In order to activate the alarm, move the function button (8) to the AUTO position. If you would like to be woken up by a buzzer, move the RADIO/ON/OFF/AUTO button (8) to the middle position. The alarm can be switched off for approximately 5 minutes with the snooze button. After approximately 1 hour the alarm switches off completely until the following day. [. . . ] Motor pistons, kneading hooks, drive belts, spare remote controls, spare toothbrushes, saw blades, etc. ) nor the cleaning, maintenance or change of wearing parts fall under this warranty and hence are subject to payment of costs!Once the warranty has expired, repairs can be carried out by specialized technicians or repair services against the payment of the service. [. . . ]