User manual COMPRO S300 START UP GUIDE

[. . . ] External Use the supplied audio cable to the Line-In Audio-Out port of your sound card. Composite-In Use a Composite video patch cable to connect to a video source. 3 Hardware Installation Warning !! Unplug your PC's main power cord before installing VideoMate S300. Failure to do so may cause damage to your VideoMate S300 TV tuner card and void your warranty. 1. Warning!!: Please shut down your computer and unplug the PC power cord before installation the TV card, and then remove the PC case cover. 2. [. . . ] 8 Playback Press the Play button to open the Play dialog box. Timeshifting Timeshifting temporarily saves the video to your hard disk for a specified period of time so that you can pause, replay, or skip commercials during live TV, without interrupting an ongoing recording session. Press the Timeshifting button and the Time Monitoring bar will appear. You may also press the Advance (for commercial skip) and Replay (for instant replay) buttons on the control panel or remote control to navigate through the program. When you return to your seat, you can resume viewing the program from the point when you left. Options You can press the Options button to open the Options dialog box. Easy Mode Easy Mode is for user who have connect the satellite signal directly to Satellite TV card without passing through DiSEqC switch. Please select the satellite that your satellite dish have been aimed to and press "Autoscan" to scan channels. Single Single mode and rest of the mode are for user who wants to have advance settings like LNB, DiSEqC1. 2 motor control and etc. It also has two other scanning modes like "Transponder Scan" and "Scan the specific frequency ONLY". 9 Transponder Scan This scanning mode is for you to specifically scan a transponder that you know instead of scanning the whole satellite. When scanning in this mode, it will add the channels you have scanned to your channel list. You will need to know some information on the transponder that you wish to scan first. Scan the specific frequency ONLY This scanning mode will specifically scan a frequency; usually used when the signal is weak and has been lost during other type of scanning mode. LNB Settings This settings need to follow the instruction from the Satellite's LNB spec. If you already have other working device that can receive the signal from the satellite (i. e. If you still have problem with LNB settings, please contact your satellite dish provider for correct information. DiSEqC1. 2 motor control setting Compro S350/S300 supports DiSEqC 1. 2 version. If you have installed motor that compatible to DiSEqC, it may aim to different satellite to receive different satellite's channels. 2 ports 22KHz switch / 2 ports mini DiSEqC switch / 4 ports DiSEqC1. 0 switch / 4 ports DiSEqC1. 2 switch These four settings are similar to Single mentioned above. The difference is these four settings have connected the LNB to the TV card through a switch. Please refer to the picture in each setting to confirm which switch you are using, then continue with the advance settings. 10 Each of these mode will have 2~4 tabs to switch between different satellites (i. e. under "4 ports DiSEqC1. 2 switch" will have Port S1, Port S2, Port S3, and Port S4 tab) Note Compro S350/S300 supports up to 4 ports DiSEqC switch. Before using autoscan, you may need to confirm the LNB connection and settings are correctly setup. After channel scanning, ComproDTV will receive the correspondent channels of the satellite. [. . . ] Please check if there are any microwaves or lights that may be doing this. And make sure as few cables as possible are crossing the IR receiver. Contacting Compro Technical Support Before you submit an email for support, please check support FAQs on our web site. http://www. comprousa. com/support You can download the latest update from our website. When contacting Compro for technical support, please use the Compro support request form and provide as much of the requested information as possible. [. . . ]